When did GM stop making Hummer H2?

2009
Production ceased 2006, but HMMWV production continues. AM General Hummer H2 Assembly Plant, Mishawaka, Indiana – 673,000-square-foot plant (62,500 m2) opened 2002. H2 production ended 2009.

What are the most common problems with Hummers?

1 Engine Runs Rough. The biggest issue with this vehicle seems to be its rough running engine. 2 Blown Head Gasket. Many H3 owners, particularly the model year 2006 discovered that the Head Gasket blows off when the vehicle crosses the 100k mile. 3 Check Engine Light. 4 Cylinder Head Failure. 5 Leaking Valves. …

Are there any problems with the Hummer H3?

Rather than recall the problematic vehicles, it treated them on a case-by-case basis. Some owners were out of warranty when the problem occurred and had to foot the bill. Another big issue with the Hummer H3 was its weakened cylinder heads and valve seats.

Are there any problems with the AM General Hummer?

During manufacturing, there was a flaw in the number eight cylinder casting of the turbo diesels at GM’s plant. Fortunately, AM General replaced faulty engines under warranty. But not all the affected vehicles may encounter the problem during the warranty period. You want to check that the model you are buying does not have this problem.

Are there any problems with the 2006 Toyota H3?

In fact, the 2006 H3 was so problematic for many owners, and most of the problems were from factory defects. Here are some major issues with the H3: The biggest issue with this vehicle seems to be its rough running engine. When the vehicle gets past the 50k mile, you notice that the engine runs rough, even while idling.

What is the owner’s manual for a 2003 Hummer H2?

The 2003 HUMMER H2 Owner’s Manual i The 2003 HUMMER H2 Owner’s Manual 1-1 Seats and Restraint Systems This section tells you how to use your seats and safety belts properly. It also explains the air bag system. 2-1 Features and Controls

How does the memory work on a Hummer H2?

2. Press and hold the 1 or 2 (for driver 1 or 2) button of the memory control for three seconds. A double chime will sound to let you know that the position has been stored. To repeat the procedure for a second driver, follow the preceding steps, but press the other number of the memory control.

Where is the power lumbar control on a Hummer H2?

1-3 Power Lumbar Control Use the lumbar control, located on the outboard side of the seat, to increase or decrease lumbar support in an area of the lower seatback. To increase support, press and hold the front of the control. To decrease support, press and hold the rear of the control.

Is the Hummer a trademark of General Motors?

ii GENERAL MOTORS, GM, the GM Emblem, HUMMER and the name HUMMER are registered trademarks and H2 is a trademark of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.