What to do if your car dashboard lights are not working?

Removing the old fuse and replacing it should get the lights working again. While the new fuse may do the trick, it could also indicate a deeper electrical problem. If the new fuse doesn’t last long, have it inspected at an authorized Chevrolet service center since you may have a deeper problem in the electrical system.

Where are the lights on the dashboard located?

Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch. Tail lights and dash lights are connected through the tail light (and/or brake light) fuse.

How can i dim the lights on my dashboard?

Begin the process by trying the simplest of solutions first. Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column or part of the headlight switch.

Why are the warning lights on my car not working?

One or more dashboard warning lights don’t work. If one or more warning lights fail to illuminate when you first turn the key on, it usually indicates a blown bulb. If none of the lights come on at all, check the fuses and wiring to the instrument cluster first.

What to do if your dash light does not work?

#Test the dashboard light bulbs. If the fuses are working properly, check for a blown bulb in the dashboard. Following the manufacturer’s instructions, disconnect the battery while working on the dash, remove the faceplate covering your vehicle’s dashboard gauge panel. Remove the screws holding the plate on. Carefully remove the faceplate.

Where is the fuse on the dash light?

The fuse box may be under the hood, or near the floor, near the brake pedal, or there may be two fuse boxes in both places. Refer to the diagram on the fuse box cover to locate the correct fuse. Replace the dashboard light fuse if necessary. Note: also check if the tail lights are working.

How are the tail lights and dash lights connected?

Tail lights and dash lights are connected through the tail light (and/or brake light) fuse. When the dashboard goes dark you know you are driving without tail lights. [ [Image:Fix Dashboard Lights That Won’t Light Step 2 Version 3.jpg|center]]

Why are the headlight doors on my C5 Corvette not closing?

The headlight doors on my C5 corvette wont close with the engine turned off. Is this normal? Just bought a 2002 coupe and noticed that the passenger tempeture control knob doesn’t change the temperature display when you turn the knob up or down. …

What to do when your Corvette C5 wont start?

Pull the correct fuses (found in the owners manual) and reset the codes. If that doesn’t work you can try this little trick: set the heat on high, shut the car off, discount the battery on the negative side, wait five minutes, reconnect and see if your problem has gone away.

What did my 1999 C5 Corvette die of?

1999 C5 corvette died after starting 3 times after I put it in gear. The I started it and revved it up a few times and it drove fine for about 5 miles. … When i put key in to start my C5 vette gages go crazy lights flash security light goes on car turns over but then shuts off .

Why are the dash lights not working on my Corvette?

The wiring diagram indicated that there was a delay/timer in the dash light circuitlocated near the switch. I bypassed the timer by simply plugging the input/output plugs together, and the dash lights worked, but turned off immediately when the car was turned off. I think the delay left the lights on a few seconds after the car was turned off.

What are the most common problems with a C5 Corvette?

The most common issues you are going to run across when it comes to C5 Corvette electrical problems are bad grounds. Your C5 Corvette comes with 13 different chassis ground points around the car, all of which are subject to corrosion or coming loose causing a bad connection.

Is it possible to reset the warning lights on the dash?

This will result in a warning light appearing on your vehicle’s dashboard. After the repair is complete, however, it may still be necessary to reset your the computer in order for the warning light or lights to disappear. Fortunately, this process is fairly simple. Open the hood of your vehicle.

What do the warning lights on the dashboard mean?

Only a flashing red light means pull over immediately. There are three dashboard light colors on most dashboards: yellow, red, and orange (and, occasionally, blue or green). The most severe alerts are displayed in red or orange.

Where is the control switch on the dashboard?

Check the control switch, which should be located on the console near the steering column or part of the headlight switch. [ [Image:Fix Dashboard Lights That Won’t Light Step 1 Version 3.jpg|center]] #* If you are having trouble locating the dashboard lights control switch, refer to your vehicle’s owner manual for further assistance.

What to do if your Ford dashboard light comes on?

Make an appointment with your local dealer as soon as possible. Charging System: If you’re driving while this light comes on, switch off all unnecessary electrical equipment that you may have running and get your vehicle checked by an authorized mechanic immediately.

What should I do if I see a warning light on my car?

More than likely, you have run out of coolant, or there is a serious issue with the temperature gauge. Check your coolant levels. If you’re at the appropriate amount, do not move your car—have it towed to the nearest mechanic. Engine Oil Pressure: This is one of the more critical warning lights.