What should I do if my roof on my convertible stops?
What should I do if my roof on my convertible stops?
The best fix (IMHO) is to use a bolt to maintain pressure exactly where the gear is. Bolt method The top may stop a few inches from the windshield while opening or closing. This likely indicates a broken wire. A broken wire may make just enough contact to maintain electrical conductivity, until the roof moves.
Where is the top motor on a convertible?
If the level drops below the MIN, the convertible top will either not operate at all or move too slowly, not close, or stop halfway. Locate the convertible top motor. In most convertibles, it is located in the trunk behind the lining. Also, check near the spare tire or behind the rear seats.
Why is my convertible top not working properly?
Check cylinders for fluid leaks. Another common reason why convertible tops fail to operate is due to leaks at convertible lift cylinders. The hydraulic cylinders move the hardtop or soft-top up and down. They have seals and o-rings that shrink and crack due to age.
Why is Max not marked on convertible top?
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.
The best fix (IMHO) is to use a bolt to maintain pressure exactly where the gear is. Bolt method The top may stop a few inches from the windshield while opening or closing. This likely indicates a broken wire. A broken wire may make just enough contact to maintain electrical conductivity, until the roof moves.
Check cylinders for fluid leaks. Another common reason why convertible tops fail to operate is due to leaks at convertible lift cylinders. The hydraulic cylinders move the hardtop or soft-top up and down. They have seals and o-rings that shrink and crack due to age.
How to troubleshoot a Mercedes Benz convertible problem?
You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run. Replace the convertible top relay if necessary, PN 0025421319. Next, check the micro switch where the divider locks. You know that trunk separator that you are supposed to pull out and engage it in this hook?
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.
What does it mean when your convertible top stops working?
It is great that you have performed the reset procedure already as that is typically the first step in diagnosis. In most cases when the electrical noise is heard and the convertible top motor is heard trying to work this indicates that the top is receiving power.
