What kind of trim does a 1967 Corvette have?
What kind of trim does a 1967 Corvette have?
1966-1967 Corvette . 1966-1967 Corvette Nos Gm First Quality Chrome Grille – Gm Part No. 3875746 1963 Corvette . 1963 Corvette Coupe Rh Door Outside Moulding, Trim, Passenger, Part 3822512 1954 Corvette . 1954 Corvette Windshield Frame Lower Stainless Steel Trim Molding New 55 53 C1
How do you take windshield trim off a car?
The windshield trim comes off by taking the wiper escutcheons off, then the lower trim, then the corner trim pieces. You can’t take the upper windshield trim off without removing the windshield.
How do you install windshield glass in 1955?
Image #13: Carefully slide the lower windshield moldings onto the clips attached to the cowl screen or cowl. Image #14: With the lower moldings slid onto the clips on the cowl screen, bow the moldings slightly and slide them into the lower corner moldings at the same time passing the stud of the outer clip through the holes in the cowl.
What is clip set number for 1955-57 windshield?
Image #11: The lower windshield moldings are held to the body with clip set PIN 57-135530-1. The large center and two small mid clips attach to the cowl screen (1955-56)or cowl (1957) with #6 sheet metal screws.
How do you remove a windshield in a corvette?
A roll of windshield removal wire was also ordered. The wire is used to cut through the factory butyl tape that holds the windshield in the frame. After removal of the T-tops, the sun visors are the first interior components to be removed. The windshield header trim is the next component removed.
1966-1967 Corvette . 1966-1967 Corvette Nos Gm First Quality Chrome Grille – Gm Part No. 3875746 1963 Corvette . 1963 Corvette Coupe Rh Door Outside Moulding, Trim, Passenger, Part 3822512 1954 Corvette . 1954 Corvette Windshield Frame Lower Stainless Steel Trim Molding New 55 53 C1
What causes rust on the windshield of a corvette?
Over time debris from leafs; dirt and other substances will build up under the windshield outer stainless steel moldings and/or the upper windshield trim and over time these will hold moisture and thus rust. Another issue is the way the Corvette windshield frame was constructed!
What should I use to replace my C3 windshield?
A Dremel or other high¬speed handheld grinder comes in handy for cutting the heads off these stubborn screws. Prior to removing the “T” trim, use a screwdriver to pry the upper exterior stainless windshield trim, since the “T” trim sits underneath this trim piece. Gently pry the “T” trim up, moving only 2-3 inches at a time across from both sides.
