What kind of steering gear does a Dodge truck use?

Dodge trucks suffer from three problems in this regard: A poorly designed joint connecting the spline shaft of the steering gear to the shaft which connects to the steering wheel via a rag joint The Saginaw 708 steering gear (used, I believe, from 1979 – 1993), which develops leaking seals

How to replace the steering shaft on a Dodge slop?

Installation of the replacement shaft takes all of about 20 minutes: Using a hammer and a punch, gently tap out the roll pin which holds the flexing joint from the steering shaft to the spline shaft of the steering gear Using 3/8 inch wrenches or sockets, disconnect the steering shaft at the rag joint

How do you replace a steering gear spline?

Pull the flexing joint off the steering gear spline shaft, and remove the shaft Installing the Borgeson replacement would simply require sliding its flexing joint onto the spline shaft, attaching at the rag joint, and tapping in the roll pin. You have to be careful to align the splines to allow the roll pin to sit properly.

What kind of steering box does a Mopar truck have?

Answer by Sam Bledsoe: The base steering gear was a manual unit from 1972-1977, and most military M880’s were manual steer trucks. The 1972 4WD thru 1977 4WD had the same style Power Steering box unit. Then came the 1978 thru 1993 units that had the “stamped steel” mounting bracket and a different rotation steering gear.

How long have Ramcharger steering boxes been made?

The Ramcharger steering boxes were only made for two years and thus are expensive and hard to come by. I somehow got stuck with two and spent two hours researching what on earth they were from. Questions We Could Use Some Help With: 1. Is there a rebuild kit available for the older style steering u-joint?

Where is the steering box on a Dodge Ram?

Turn your ignition key one click to unlock steering wheel, but do not start the engine. Also, make sure the steering wheel is centered. The steering box is located underneath the driver’s side front end of your truck and is connected to the Pitman arm. Use a 4.5mm Hex wrench to hold the adjustment bolt on the steering box in place.

Why is there play in my steering wheel?

If your Dodge Ram’s steering wheel has more play than usual, don’t be too concerned. A few simple fixes could solve your problem. This article applies to the Dodge Ram 2nd and 3rd Generation (1994-2008).

What to do with steering fluid in Dodge Ram?

Use a turkey baster to remove the old power steering fluid from the reservoir. Turn the steering wheel left and right to remove any remaining fluid in the reservoir. Then refill the reservoir with Mopar ATF+4 fluid. Start the engine and turn the steering wheel left and right.

How often do you turn the steering wheel on a ram truck?

Remember watching those old B&W television shows where the driver of his 1950’s pickup truck had to turn the steering wheel a half-dozen times just to negotiate a simple left turn? It looks like a pain, and as your Ram truck begins to rack up the miles, you’ll probably notice a bit more play in the steering wheel as well.

What kind of steering gear does a Dodge truck use?