What kind of brake light does a 1976 Corvette have?

I have a 1976 Corvette. The drivers side brake light turns on when pressing the brake pedal, but when it lights up it’s really dim. And just a few minutes … replaced all calipers and master cyl,& brake pads.

Can a 1980 Corvette turn over or start?

1980 corvette battery tests that it is good, but the car will not start or turn over. new gauges for 1975 vette don’t seem to work properly. Bought new gauges for my 1975 vette from Ecklers. Fuel gauge reads 1/2 tanks yet i ran out of gas?? Water gauge reads 100 but should read around …

What kind of engine does a 1975 Corvette have?

1975, 350 automatic. timing was off-backfired 3 times,newer edelbrock 1406 carburetor non egr electric choke, new spark plugs, ignition wires, cap and … My 78 vette low beam are fine but when I step on high beam button all 4 headlights go off.

What’s the problem with the window on a corvette?

Removed window for painting.Having problem re attaching with hinges, window not alighning with hinges properly no shims yet must be easier way.how do you … Where is the defroster cable? I can hear a slight noise with the clutch out and car in netural when I press clutch in slighty the noise goes away. adjustment needed?

Why is the seat belt buzzer on my Corvette not working?

The seat belt buzzer for my corvette won’t shut off and I cannot find the relay to remove it to shut it up. Can anyone direct me to the place where … Click here to write your own. I have a 1977 corvette. To put the back main gasket in, can you pull the oil pan and put it in from there?

How to ask a question about a C3 Corvette?

On C3 Ask Corvette Garage you can submit a question about problems you have with a C3 Corvette. One of our writers or a fellow Corvette enthusiast will reply ASAP. Also you can Respond to other peoples questions.

How is the center console taken apart on a 1980 Corvette?

It has been about a month and a half, but went out to start my car , and it was dead, so I replaced the battery, and car turns over like a champ but will … The air flow only comes out of the floor vents. How is the center console taken apart in order to get to the heat and a/c controls on 1980 vette in order …

Are there brake pedals in an original Corvette?

The clutch and brake pedals are refurbished original Corvette. NOTE: You will notice a slot in the bracket above the clutch pedal. This slot is for the rubber bumper which cushions the pedal when it returns. The cushion comes with the kit.

Where does clutch return spring go on Corvette?

Install the clutch return spring from the ‘Z’ shaft to the firewall bracket that retains your steering column. Your linkage assemble is now complete from the clutch pedal to the ‘Z’ shaft. You will want to fill the ‘Z’ shaft with grease at some point. You will see the hole in the bottom of the shaft for a grease fitting.

How do you install a clutch bracket on a corvette?

Unless you have an arc welder in your shop, while your car is still mobile the first task is to find your favorite welding shop and have the ‘Z’ clutch shaft bracket welded to the frame. It is easy to locate the correct mounting point for the bracket if you install the ball stud on the engine block.

Where is the automatic shift mechanism on a 1977 corvette?

With the fiberglass floors used right up to 1976 there were no differences in the panels. After removing the automatic shift mechanism from the tunnel you will see an indentation under it. This indentation happens to be right where the standard transmission shifter comes through the tunnel. This needs to be cut out.

Why does my 1980 Corvette not turn over?

She always started right up until it got wet. Turns over strong sprayed ether in carburetor she wants to rip but it’s just shy of catching did have … 1980 corvette battery tests that it is good, but the car will not start or turn over. new gauges for 1975 vette don’t seem to work properly. Bought new gauges for my 1975 vette from Ecklers.

What kind of brake light does a 1976 Corvette have?