What is the ICP on a 2000 DT466?

What is the ICP on a 2000 DT466?

2000 4900, Dt466E. Tried starting engine, after a couple seconds 2000 4900, Dt466E. Tried starting engine, after a couple seconds pro-link shows icp at 150psi and falling. Should that be? … read more

What are the codes for 2006 International 4300 DT466?

2006 International 4300 DT466. I have codes 254 (controller 1 fault) fault mode id 8 and 6. Also code 164 (egr pos DT466..I have codes 254 (controller 1 fault) fault mode..pos… Auto Mechanics 1&2/diesel…

What kind of engine does an international dt466e have?

The truck is an International 2004-2006, Model 4300, Engine DT466E with an Allison MD transmission. The rated HP is 245. 1. DTC: 222, SPN: 247, FMI: 2 Break Switch Circuit Fault; 2. DTC: 353, SPN: 27, FMI: 5 VGT Over Duty Cycle; After I got the DTCs from ServiceMaxx I was able to find some info on the 222 from the ISIS software.

What’s the code for a DT 466E diesel truck?

We got couple of 05 International truck that has VGT problem. Code 152 (BAP signal out of range low). 354 (VGT control under duty cycle) and Body Controller – Remote Engine Speed Control #1 – Analog input #2 shorted to ground. Already replace BAP sensor, MAP sensor and VGT turbo.

What’s the trouble code for a 1995 dt466e?

That is good for 1995-1999 DT466E engines. Good Day! I’ll sticky this for you guys…. I can also post the newer engine DTC lists if you would like. If you could post the trouble codes for the later DT466E i would appreciate it. I have ordered the Intl. CD Manual but would like to start on the codes in my 2002 truck.

Where is the cam sensor on a DT466?

The cam sensor is located on the passenger side of the front timing cover and reads engine rotation that relays a reading to the ECM (engine control unit). As I stated before if the cam sensor does not send a signal to the ECM the engine dies since the ECM thinks that the engine is not rotating and it’s programmed to shut down the injection system.

When to warn Engine Lamp on DT 466E?

*- Indicates WARN ENGINE LAMP on when fault is set. That is good for 1995-1999 DT466E engines. Good Day! I’ll sticky this for you guys….