What is the Ford high pressure oil pump part number?

What is the Ford high pressure oil pump part number?

– Genuine Ford Part Number 4C3Z-9B246F STC Fitting upgrade kit (This kit repairs a design problem with the STC (Snap to Connect) fitting that was a common cause of high pressure oil leaks. The new style fitting is already removed from the kit and installed on the high pressure pump for you.

Is there a 6.0L Powerstroke high pressure oil pump?

Only 15 left in stock – order soon. 6.0L Powerstroke STC HPOP Fitting Update Kit – Compatible with Ford F250, F350, F450, F550 Vehicles – 6.0 Powerstroke Diesel – Replaces 4C3Z-9B246-F – High Pressure Oil Pump – 2004.5, 2005, 2006, 2007 .

What happens if your high pressure oil pump fails?

In a large majority of cases where the high pressure oil pump has failed, we find that the high pressure oil pump screen is torn. If the screen is not replaced, the high pressure oil pump will fail again in a very short period of time. Some additional time and effort is required to check and replace the screen – but it will save significant time…

Where is oil leak on riffraff 7.3 Powerstroke?

Riffraff Diesel sells a replacement rear plate o-ring seal. 7.3 oil leaks at the HPOP gaskets are also pretty uncommon. There’s one between the the HPOP reservoir top cover and bottom oil reservoir — the HPOP “Reservoir Gasket.” Another one — the HPOP Mounting Gasket — sits between the HPOP and front engine cover.

Is there a high pressure oil pump for a Ford F250?

High Pressure Oil Pump HPOP For Ford F250 F350 F450 E350 E450 Super Duty Excursion 6.0L PowerStroke Diesel 2003 2004 – BuyAutoParts 34-60015R Remanufactured 3.9 out of 5 stars4 $687.41$687.41 FREE Shipping Only 2 left in stock – order soon.

Where is the IPR valve on a 7.3 power stroke engine?

With a little care and the right tool, an IPR valve can be removed from a 7.3 PowerStoke engine in minutes. The IPR is located on the back of the high pressure oil pump (HPOP), which is located under the fuel filter assembly, down in the “V” of the engine. The IPR valve has been largely unchanged since its introduction in 1994.

Is there a way to remove the IPR valve?

The easiest way to remove the IPR valve is to build a special IPR removal tool. Some Ford dealerships remove the HP oil pump to change/service the IPR. With this tool, it can be done in minutes. Said tool is comprised of a 1/2″ 29mm drive deep 6 point or 1 1/8″ socket with a 4 or 5 inch piece of 1″ flat steel welded across the back of it.

How to replace a PowerStroke fuel injector valve?

SAVE 70% ON COST FOR A PROPER OEM FIT: OEM standard and finish, direct replace factory part F5TZ9C968A, F81Z9C968AA, F81Z9C968AB, 1829856C91 and 1841217C91 for a proper fit every time. WHY REPLACE FOR YOUR TRUCKS POWERSTROKE: IPR valve regulates fluid pressure for the high-pressure oil system in powerstroke engines.