What is the error code for Hitachi excavator?
What is the error code for Hitachi excavator?
So it is important for us to know some error codes of Hitachi excavator sensors. Let’s introduce in detail: 636-2 Camshaft angle sensor is abnormal (no signal). Although the crank signal appears, the cam signal does not appear.
What to do if your Hitachi AC unit is not working?
Check for obstruction of air flow of the outside or inside units. Check if too much heat source exists in the room. Check if the air filter is clogged with dust. Check to see if the doors or windows are opened or not. Check if the temperature condition is not within the operation range. Check for electrical wiring. Check for dip switch setting.
When to troubleshoot by Alarm Code in Hitachi?
In the case that “RUN” lamp flashes 5 times (5 seconds) with unit number and alarm code displayed, refer to the next item “18.2 Troubleshooting by Alarm Code” and the “Service Manual”. In the case that no alarm code is indicated and normal operation is not available, refer to the “Service Manual” because abnormality of some device is suspected.
Why does my Hitachi excavator keep shorting out?
On the older Hitachi excavators there was a diode installed behind the operator’s seat that had to do with the glow plug circuit. Basically one of the glow plugs would short out and pull a big current that would burn out the diode. You could find this by checking for burn spots on the glow plug bar.
So it is important for us to know some error codes of Hitachi excavator sensors. Let’s introduce in detail: 636-2 Camshaft angle sensor is abnormal (no signal). Although the crank signal appears, the cam signal does not appear.
Is the Hitachi 120-3 excavator has hydraulic problems?
Discussion in ‘ Excavators ‘ started by tommurphy73, Dec 8, 2017 . I have a Hitachi 120-3 excavator which has hydraulic / electronic problems. The machine has very slow hydraulics including the track motors. It operates a little like the excavator in this video
What to do if your Hitachi Zaxis has a ground disconect?
Turn the key on, don’t start the engine and check the wire for voltage. Next disconnect the wire and try to start the engine. If it starts you need an alternator repair. Good Luck! Does your Hitachi Zaxis, have a ground disconect like Komatsu does?
What are the symptoms of a Hitachi fault?
Operating symptoms of the machine when the fault occurs: (1) boom lifting speed does not increase when HP is under control; (2) stick retraction and boom lifting combined operation stick speed is slow The above mainly introduces the error codes related to Hitachi sensors.
