What is the correct bolt length for a high pressure fuel pump?

What is the correct bolt length for a high pressure fuel pump?

The correct bolt length is 35 mm (1.37 in.).‪ Install four bolts securing the high pressure pump to the flywheel housing and torque to 60 N·m (44 ft·lb). Install two nuts securing the high pressure fuel pump to bracket and torque to 30 N·m (22 ft·lb).

How to remove high pressure fuel pump bracket?

Remove two bolts securing the high pressure fuel pump bracket to engine block. Remove two nuts securing high pressure fuel pump to bracket. Remove four bolts securing high pressure fuel pump to cylinder block.

How do you mount a fuel injection pump?

Verify the proper torque in your engine service manual. Install the gear cover access cap hand-tight. Install the fuel injection pump mounting bracket screws. Tighten all screws by hand for proper alignment, then torque. Connect the external oil feed line at the inboard side of the fuel injection pump (if applicable) and the main oil rifle.

Where is the high pressure fuel pump located?

The fuel high pressure pump is located at the rear on the left side of the cylinder block and is driven by the pinion gear drive.

Where are the nuts on a BMW fuel pump?

Remove all eight 10MM nuts and you will see the top of the fuel tank and both units installed in them with the famous BMW lock ring holding them in place. The picture below is the actual fuel pump unit on the passenger side with the black cover removed and exposed.

Do you need lug nuts for fuel off road wheels?

Fuel Off-Road does not manufacture lug nuts or wheel locks. These are sourced and supplied by your installer. Some locks all use the same key while more premium products use proprietary codes and patterns for replacement keys. Contact the retailer that installed your wheels and tires and they can assist you in ordering a replacement key.

Can you drive with a bad fuel pump?

So technically, yes, it’s possible to see a code as a result of a bad fuel pump. Q: Can you drive with a bad fuel pump?

How do you remove a fuel filter from a fuel pump?

Remove the central screw or nut from the top of the fuel pump housing. There will be a nut or a bolt sticking out of the top of the mechanical fuel pump that holds the cover over the fuel filter. Find it and then use the correct sized wrench to remove it so you can access the filter inside.