What happens if clutch cable is too loose?
What happens if clutch cable is too loose?
Loose clutch pedal A broken or incorrectly adjusted cable can result in a clutch cable with excessive slack. This will cause the pedal to have too much free play when depressed before resistance is encountered and the cable starts retracting, and will result in a clutch that does not disengage properly or all the way.
How do you adjust the clutch cable on a motorcycle?
When it’s turned all the way in like this one, you have run out of adjustment, and therefore it’s time to… … hit the adjuster at the other end of the cable. On my R1, that’s down at the clutch, on the other side of the bike. Loosening the nut on the left with a 12mm wrench lets you pull the cable and sheath free.
Where is the adjuster on a Mustang clutch?
Route the cable so the end of the outer housing seats squarely against the adjuster mechanism. The transmission end of the clutch cable housing must remain at a right angle to the bell housing. The stock retaining clip, located underneath the clutch fork cover, keeps the cable in the correct position.
Do you need to adjust the clutch pedal?
The clutch should engage smoothly. This will also seat the clutch cable fully after a few depressions. Now measure the clutch pedal freeplay as outlined in part one. The free play should be within manufacturer’s range specifications now. If it is not within specifications, you will need to adjust the cable again.
What should tension be on clutch cable on Mustang?
While continuing to pull the outer cable housing away from the firewall, rotate the adjuster to thread it in or out of the firewall until the gap is about the thickness of a dime (0.050″). The cable should have just enough tension that the pedal moves down 1/2 in. when you press it with 5-8 lb of force.
When it’s turned all the way in like this one, you have run out of adjustment, and therefore it’s time to… … hit the adjuster at the other end of the cable. On my R1, that’s down at the clutch, on the other side of the bike. Loosening the nut on the left with a 12mm wrench lets you pull the cable and sheath free.
What happens when you shorten the clutch cable?
Never mind clockwise and counterclockwise and all that; all you need to know is that when you shorten the sheath via its adjusters, you’re effectively lengthen ing the cable inside, thereby providing more slack. There’s one adjuster up next to the lever you can adjust by hand.
What is the sheath of a clutch cable?
So, the cable sheath is the outside black vinyl part that the cable runs through. Never mind clockwise and counterclockwise and all that; all you need to know is that when you shorten the sheath via its adjusters, you’re effectively lengthen ing the cable inside, thereby providing more slack.
How much slack should be at the end of the clutch?
This is the primary reason why my 2000 R1 Service Manual says there should be 10 to 15 millimeters of free play at the end of the clutch lever. You want to make sure that when the clutch is fully engaged – as in when you’re no longer pulling on the lever at all – that there’s enough slack in the line to allow the plates to be fully engaged.
