What does the radiator do on a Dodge Ram 1500?

This article will guide you through the process. This article applies to the Dodge Ram 1500 2nd and 3rd Generation (1994-2008). The radiator is designed to keep the Dodge Ram’s monstrous engine cool. It circulates coolant through the engine to ensure it stays cool under any driving condition.

What can you tell me about the Dodge 318?

The 318 is a great motor. The only issue they had was sludge build up in the oil passages if you didnt stay on top of oil changes. They can be built to actually push more power than a 360, and they rev a heck of a lot faster than the 360. We did a head swap with a set of 360 R/T heads and it helped alot.

What kind of engine does a Chrysler 318 Magnum have?

The Chrysler 318 Magnum features a cast-iron block and two cast-iron heads with a single camshaft (OHV) and two valves per cylinder (16 valves in total). The Chrysler 3.9L Magnum engine is equipped with a multi-point fuel injection system and a mechanically timed electrical ignition system with an ignition coil and mechanical distributor.

What to do if your Dodge Ram heater is not working?

If playback doesn’t begin shortly, try restarting your device. This channel is based off of “ALL THINGS COOL” Reviews that range from everyday items like tvs , electronics, gadgets, outdoor gear, cars, how to videos, just about covers everything category of whats cool for that average consumer.

What is a cold air intake on a Dodge Ram?

A cold air intake is more effective when combined with a tuned MAF sensor, a wider throttle body, and a tuned PCM. Figure 3. Cold air intake. The throttle body is a flap that controls how much air flows into your engine. This mod consists of boring out the cylinders 2mm wider and installing new throttle body plates.

What kind of engine does a Dodge 318 have?

Production of this engine lasted until 2003, when it was completely replaced by the newer 4.7L PowerTech SOHC V8 engine. [10] The 318’s I’ve owned were bullet proof.

Why is the coolant leaking on my Dodge Ram 1500?

Coolant Leaks Multiple coolant leaks are one of the more common 2015 RAM 1500 problems, as well as affecting model years 2009-2014. Many owners report that the leaking is strange because it’s difficult to locate even with a pressure test and that the leak only occurs when the engine is cold.

Are there any problems with the Dodge Ram 1500?

Fourth-generation Dodge Rams are more powerful than these trucks have ever been, yet they’re still susceptible to issues that can make them dangerous to drive. Electrical issues are unfortunately common in late-model RAMs and are some of the worst 2010 RAM 1500 problems. 1. TIPM Issues

How do you flush a Dodge Ram radiator?

After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times.

How do you replace coolant in Ram 1500?

In this video we show how the RAM 1500 coolant flush replacement is done easily by draining the coolant and refilling the system. You may be replacing the thermostat or just replacing old coolant but either way the drain and fill procedure is the same!

How to flush a Dodge Ram with distilled water?

Leave the bleeder plug on the thermostat housing out for now. Now is the time to attach the spill proof funnel to the radiator. Fill the radiator with distilled water until it comes out of the thermostat bleed plug hole. Its going to take close to 2 gallons of water before that happens. Once it comes out put the bleeder plug back in.

How to flush the coolant on a Ram 1500?

Locate Hoses – Locate the coolant hoses and connection points 12. Burp System – Remove excess air in the cooling system 13. Cap Radiator – Replace the radiator cap 14. Replace Cap – Put the reservoir cap back on

What kind of coolant does a Dodge 1500 use?

The Mishimoto Liquid Chill Synthetic Engine Coolant for the Dodge Ram 1500 Pickup takes third-place on our list. This engine coolant ensures that your engine’s temperature always remains in the desired temperature range of 265°F to -26°F. This allows it to reduce engine wear and inhibit corrosion and keep the radiator of your engine safe and clean.

Where is the drain plug on a Dodge Ram?

What causes a Dodge Ram 1500 to overheat?

What are common reasons my Dodge Ram 1500 overheats? While there are a variety of reasons your Dodge Ram 1500 is overheating, the most common 3 are a coolant leak (water pump, radiator, hose etc.), the radiator fan, or a failed thermostat. When the radiator fans stop functioning properly, the engine temperature will rise.

What kind of coolant should I put in my Ram 1500?

Adding engine coolant (also known as antifreeze) to your 2012 Ram 1500 is pretty easy. Engine coolant circulates through your engine to keep it cool in the summer but won’t freeze in the winter. Make sure to check your engine when it is cold for an accurate reading.

How to flush the coolant in a Dodge Ram?

Drain Coolant – Drain the coolant from the system 9. Circulate Water – Run engine with distilled water and flush 10. Fill Coolant – Dilute coolant with distilled water and fill 11. Locate Hoses – Locate the coolant hoses and connection points 12. Burp System – Remove excess air in the cooling system 13. Cap Radiator – Replace the radiator cap 14.

Where is the coolant reservoir on a Ram 1500?

The video above shows you where the coolant reservoir in your 1500 is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Rams, it will typically be in a section titled Fluid Capacities in the back of your manual.

How much water is in a ram fluid?

Ram Fluid Capacities (1) Includes 0.9L (1.0 quarts) for coolant reservoir. (2) If equipped with Trac-lok add 0.25 pints (118mL) of Limited Slip Additive. (3) Dry fill capacity depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.

Where is the radiator drain on a Dodge Ram?

Locate the radiator’s drain valve on the bottom of the radiator. You don’t need to raise the Dodge Ram since it’s a high truck with enough room for this job. Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it’s empty. Figure 2. Loosen the radiator drain valve and drain the coolant.

How do you change the coolant in a Dodge Ram?

Tighten the drain valve and pour distilled water into the radiator. Open the drain valve and let the water drain out. Fill and drain the radiator until clear water runs out of the drain valve. It will take approximately three gallons of distilled water to flush debris from the radiator. Tighten the drain valve.

How do you drain coolant from a radiator?

Place a tray underneath the drain plug. Then, using your wrench, loosen the drain valve. Let it drain until it’s empty. Figure 2. Loosen the radiator drain valve and drain the coolant. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water.

Why do you need to flush the radiator on a Dodge Ram?

The radiator is designed to keep the Dodge Ram’s monstrous engine cool. It circulates coolant through the engine to ensure it stays cool under any driving condition. After a while, rust and deposits start building up inside the radiator. Flushing the system ensures it stays lubricated, rust free, and without contaminants.

Figure 2. Loosen the radiator drain valve and drain the coolant. After you dispose the old coolant, close the drain plug and fill the radiator with distilled water. Once again, open the drain valve and let the water drain out of the radiator. Repeat this process at least three times. Be sure to watch the water draining out of the radiator.

Where is the radiator drain located on a truck?

You will need to drain the radiator and fill it with distilled water, then drain it again a few times more. It’s one of the most underrated maintenance you can do for your truck, and the benefit is remarkable. Park on a leveled ground, open the hood, and remove the radiator cap. It’s located in the front of the car on top of the radiator.

How to remove transmission on Dodge Ram 1500?

With the economy the way it is, more people have resorted to trying to do their own repairs and maintenance. This is the step by step procedure for manual transmission removal on a full size Dodge Ram 1500 pickup 4 x 2, 3.7L V6. Flywheel, clutch, and trans re-installation coming soon. I hope this helps.

What kind of transmission does a 1996 Dodge Ram have?

I have a 1996 ram 4×4 5.9 l ext cab 1500. We bought the truck and thee reverse didnt work. Then we looked for a replacement tranny at a junkyard and couldnt find one. From what i understand now a 97, 98 or 99 tranny will fit in the 96 as long as its a 4×4 5.9 liter? I tried to trust a friend of mine who said he could rebuild the transmission.

Why does my 1996 Dodge Ram 1500 not crank up?

I have a 96 dodge ram 1500 4×4 5.9 automatic when I go to put it in drive I have to shift all the way down and come back up to drive and if the shifter isn’t set right the truck will not crank up ????? anybody know what this cold be? could the steering colum be bad from wear and tear over the years, im thinking a linkage problem?

How do you remove drain plug from transmission?

Pans that do not feature a drain plug must be removed. To remove the pan, loosen the bolts that secure the pan to the bottom of the transmission, then insert the blade of a flathead screwdriver between the pan and the transmission. Twist the screwdriver to break the pan’s gasket from the transmission.

What does the radiator do on a Dodge Ram 1500?