What does the p0700 GMC Transmission Control System code mean?
What does the p0700 GMC Transmission Control System code mean?
The ECM stores the P0700 GMC code and it means the TCM detected a malfunction with the transmission controls.
What should I do about my p0700 code?
Possible Solutions For Fixing the P0700 Code 1 – Topping off or replacing the transmission fluid 2 – Repairing or replacing the wiring harness 3 – Replacing the TCM
How much does it cost to repair a GMC p0700?
The cost to diagnose the P0700 GMC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What does the p0700 GMC code mean on a car?
P0700 Gmc Description. The transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. When the TCM detects a malfunction with the control, a signal is send to the Engine Control Module (ECM) to trigger the Engine Light or Service Engine Soon light.
When is the code p0700 set in the powertrain computer?
When the code P0700 is set in the Powertrain Computer, it means that the Powertrain Computer or PCM is seeing greater than a specified RPM difference between the rotational speed of the Input RPM Sensor and the Transmission Output RPM Sensor.
The cost to diagnose the P0700 GMC code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What should the slip speed be on a p0700?
When looking at the Toque Converter RPM versus the Input Shaft RPM, observe if the scan tool data has a Converter Slip Speed PID or Parameter Identification. This can be very helpful in the diagnosis of an intermittent P0700. If the Lockup System is functioning correctly, the Slip Speed value should never be above 50 RPM.
