What does no bus mean on a 2000 dodge ram?
What does no bus mean on a 2000 dodge ram?
“No bus” is your ECM telling that one of the other computers onboard doesn’t wanna talk to the ECM. This is “usually” a wiring/connector problem. Check you wiring/connections, especially under the drivers side kick panel.
What does nobus mean?
nobody but us
From Wikipedia, the free encyclopedia. NOBUS (“nobody but us”) are security vulnerabilities which the United States National Security Agency (NSA) believes that only it can exploit. As such, NSA sometimes chooses to leave such vulnerabilities open if NSA finds them, in order to exploit them against NSA’s targets.
How to fix no bus odometer on Dodge Ram?
Turn the key back on, and now slowly apply the throttle pedal to wide open and hold it for 3 seconds and then cycle the pedal 2 to 3 times. Your giving the computer the range of the TPS. Now turn off the key again, and now restart. This generally corrects the problem as long as you have verified continuity across all the buss lines.
What causes the No Bus message on the odometer?
Symptom: Engine will not start. Gauges are inoperative. “No BUS” message displayed on odometer. Problem 1 of 2: The 5v power supply from the Powertrain Control Module (PCM) is shorted due to a shorted Crankshaft Position (CKP) Sensor.
What kind of truck has no bus gauges?
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!
Is there no bus, no gauges possible solution?
I’d like to offer my solution to the frustrating “no bus and no gauges” problem that I see is pretty common. I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type.
Turn the key back on, and now slowly apply the throttle pedal to wide open and hold it for 3 seconds and then cycle the pedal 2 to 3 times. Your giving the computer the range of the TPS. Now turn off the key again, and now restart. This generally corrects the problem as long as you have verified continuity across all the buss lines.
Symptom: Engine will not start. Gauges are inoperative. “No BUS” message displayed on odometer. Problem 1 of 2: The 5v power supply from the Powertrain Control Module (PCM) is shorted due to a shorted Crankshaft Position (CKP) Sensor.
I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type. My Story… See the end to get straight to my find. I’ve had my gauges go out with the “no bus’ message in the odometer window three times now!
I’d like to offer my solution to the frustrating “no bus and no gauges” problem that I see is pretty common. I have a 2000 ram 1500 2X with the 5.9 automatic, however I believe that this is applies to all gen2 trucks regardless of drivetrain or engine type.
