What does it mean when your car has a p1309 code?

Replacing the Camshaft Position Sensor (CMP) usually takes care of the problem, but if the sensor is installed out of synchronization it will produce the P1309 code. If the CMP is installed properly, REPLACE Powertrain Control Module (PCM). RESTORE vehicle. RERUN Quick Test . What does this mean?

When to know if your timing chain is going bad?

Far and away the best time to identify the sound of a timing chain that is about to jump is going to be listing to it when you first start the vehicle. If the timing chain is not metal, it’s really a timing belt, and they can be a lot more difficult to tell if they are going bad.

What does the p1309 Ford misfire monitor mean?

P1309 FORD Meaning Misfire Monitor Disabled When the misfire monitor is disabled, usually due to the input signal generated by the camshaft position (CMP) sensor, by sensing the passage of teeth from the CMP wheel.

How much does it cost to repair a p1309 Ford?

RESTORE vehicle. RERUN Quick Test . The cost to diagnose the P1309 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What does p1309 stand for on a cam postion sensor?

Wiki will tell you how to do the witch hunt. p1309 is a CMP (cam postion sensor) fault code. Code P1309 relates to a problem with the camshaft position sensor circuit. I thought these codes were standardized…Do these codes have random meanings assigned to them at the whim of the manufacturer?

What does diagnostic trouble code p1309 mean?

Diagnostic Trouble Code (DTC) P1309 indicates Misfire Detection Monitor is not enabled. Google it. Wiki will tell you how to do the witch hunt. p1309 is a CMP (cam postion sensor) fault code. Code P1309 relates to a problem with the camshaft position sensor circuit.

What is the trouble code for Ford Ranger p1309?

I have a 2000 ford ranger P1309 Misfire monitor AICE chip fault from http://www.aa1car.com/trouble-codes/page3.htm And sorry, but that’s all I’ve got for you. I do ok with a lot of trouble codes, but don’t know where to start with that one. (I do fear anything that says “chip fault” though).

What are the codes on my 1998 Windstar?

Codes P1537 & P1538 came up on my 1998 3.8 Windstar. Advance told me the codes mean that one or both of the Input Manifold Runner Controls might be stuck. Sure enough, one was bad. I replaced both and verified that they both work. But the P1537/P1538 codes have popped up again.

https://www.youtube.com/watch?v=xN0LXt4l6U0

What does it mean when your car has a p1309 code?