What causes wiring to get pinched between parts?
What causes wiring to get pinched between parts?
An improperly routed, improperly clamped, or loose wiring harness can cause wiring to become pinched between parts. The connector joints, points of vibration, and places where wiring harnesses pass such as through the firewall and body panels are the major areas to be checked.
Why are my intermittent trailer lights not working?
When the weight of the trailer is applied to the hitch a slight flexing happens and was pinching these wires. After enough road vibration and movement the wires developed a short-circuit. The mysterious case of the intermittent trailer lights is now solved. Well that was a weird one. I’m so glad to have my running lights back and fully functioning.
Why do my intermittent lights keep going out?
I have battled a problem of intermittent trailer running lights for a few months now. Every once in a while the marker/running lights would go out and I would find the fuse powering that circuit in the truck blown. I would replace the fuse and things would be good for a few trips then bam it would happen again.
Is there check engine light for intermittent stalling?
Many times, there will be no check engine light and no fault codes to give you a clue as to what might be causing the engine to stall. So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop.
Why is the spark plug on my Magneto not working?
The cylinder with the bad plug will be colder, if not dramatically colder. Trace the ignition harness from the “bad mag” to the cold cylinder spark plug and you will find the non-firing or misfiring spark plug. The spark plug could be lead fouled, fuel fouled, oil fouled, or effectively opened through its resistor.
I have battled a problem of intermittent trailer running lights for a few months now. Every once in a while the marker/running lights would go out and I would find the fuse powering that circuit in the truck blown. I would replace the fuse and things would be good for a few trips then bam it would happen again.
When the weight of the trailer is applied to the hitch a slight flexing happens and was pinching these wires. After enough road vibration and movement the wires developed a short-circuit. The mysterious case of the intermittent trailer lights is now solved. Well that was a weird one. I’m so glad to have my running lights back and fully functioning.
How much does a Chevy Silverado wiring harness cost?
The g. M. Dealership located the wiring harness had caught fire and melted part of the carpet on the front drivers side kick plate. $2,400. 00 to replace the harness and carpet. What’s going to prevent this from happening again?.
