What are the servicing procedures in dealing with clutch assembly?
What are the servicing procedures in dealing with clutch assembly?
Loosen all of the bolts which fix the pressure plate in place and remove it, along with the clutch disc, from the car. Inspect the flywheel closely to see if it has been damaged in any way. Remove it and clean it or replace it if necessary. Look out for oil leaks around the whole of the clutch area.
What’s the best way to adjust the clutch?
The first step in adjusting a clutch is to check the clutch pedal freeplay. This measurement will give you a baseline to go back to and you can then adjust the clutch pedal free play to fall in the manufacturer’s specification range for your vehicle.
Which is the best way to tighten a joint?
A process which achieves the required clamp force with a minimum of scatter will give a high quality joint. The process is determined by: • Torque application method; hand tightening, continuous drive and discontinuous drive. • Tightening control method; torque, angle or gradient.
How is the process of hand tightening determined?
The process is determined by: • Torque application method; hand tightening, continuous drive and discontinuous drive. • Tightening control method; torque, angle or gradient. • will give a higher confidence in the process and quality of the joint. Hand tightening is often carried out using a torque wrench.
What kind of wrench is used for hand tightening?
Hand tightening is often carried out using a torque wrench. The wrench is set to a predefined torque value and the operator will be notified when the correct torque is reached. Advantages with this solution is the ease of use and setup.
What to do if your clutch does not disengage?
Do not tighten any one bolt all at once and do not use air tools. This will bend the pressure plate and cause the clutch not to disengage. Work your way around the pressure plate slowly tightening several times until completely tight. You will notice the fingers of the pressure plate traveling inward as you tighten the bolts.
How to tighten engine bolts the right way?
1 Tighten all bolts in sequence, and in two stages to a snug torque value of say, 30 Nm 2 Apply a 90 degree rotation to all bolts in the proper tightening sequence 3 Apply a further 90 degree rotation to all bolts in the proper tightening sequence
Which is the correct way to install a new clutch?
Install the New Clutch: This part is very important! The clutch disc can go onto the pressure plate in either direction but only one direction is correct. The part of the disc that is protruding outward must go toward the pressure plate or the clutch will not release so it’s important to install the disc in the proper direction.
Which is the correct way to tighten a cylinder head?
For example, a typical cylinder head tightening sequence might look like this-. Tighten all bolts in sequence, and in two stages to a snug torque value of say, 30 Nm. Apply a 90 degree rotation to all bolts in the proper tightening sequence. Apply a further 90 degree rotation to all bolts in the proper tightening sequence.
