What are common reasons my Ford Ranger has air conditioning problems?

What are common reasons my Ford Ranger has air conditioning problems? While there are a variety of reasons your Ford Ranger air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor. What will be the outcome of an air conditioning system diagnosis?

What was the problem with the 1993 Ford Ranger?

Solution: The 1993-1997 Ford Ranger has a known blend door problem. The blend door opens and closes to either allow heat or air. The blend door is plastic, but uses a motorized actuator. Ultimately, the plastic breaks from the force of the actuator and the door can no longer be controlled.

Why are the vacuum lines on my Ford Ranger not working?

Solution: The PVH Hubs on 1998-2000 Ford Rangers clog up with dirt and stop working properly (It’s actually the rear knuckle seal that causes them to clog up). The vacuum lines are problematic as well. Click HERE for information on inspecting and repairing your hubs.

What to do if your Ford Ranger is going bad?

Some have drilled the slip yoke and put a grease fitting in to grease it during regular maintenance. Solution #2: It could also be a u-joint going bad in the driveshaft. Put the truck on flat ground, CHOCK the tires from rolling forward or backward, put it in neutral, and check for sloppy/loose parts while your under there.

How to add Freon to a 2007 Ford Ranger?

How to add freon to your 2007 Ford Ranger: hook up the can of refrigerant (likely r-134a) to the low pressure port. When your compressor kicks on, add freon to the correct pressure. In addition to cooling, freon lubricates the compressor when it runs. Advance Auto coupon for

How can I restore the cooling capacity of my Ranger AC?

Recharging the freon in your AC system is an inexpensive and easy first step to restoring the cooling capacity of your A/C system. Most refrigerants include a leak sealer that will seal small leaks in addition to filling the R134a refrigerant. The A/C system in your Ranger consists of a compressor that is belt-driven, an evaporator and freon.

What to do if your Ford Ranger has a leak?

When the air conditioner in your 2007 Ford Ranger starts blowing hot air, you likely have a freon leak. Recharging the freon in your AC system is an inexpensive and easy first step to restoring the cooling capacity of your A/C system. Most refrigerants include a leak sealer that will seal small leaks in addition to filling the R134a refrigerant.

Is the 3.0L motor problematic in the Ford Ranger?

Its like that for any underpowered engines, Autos just takes whatever little juice it has left. ALL the vehicles peeps around these parts brag on the ford 3.0, even the GM people on the used car lot. Just 1 reason I started looking for a Ranger.

Why is the a / C CLUTCH not engaging in my Ford Ranger?

The A/C requires a enough pressure on the low side to engage the clutch. It protects itself in the event there isn’t enough R134. Put a gauge on the low side (the side nearest the coolant overflow/washer bottle) and see where it’s at.

What are the problems with a 1999 Ford Ranger?

1 1: Erratic Temp Gauge Caused By Cracked Cylinder Heads 1999 Ranger Average Cost to Fix: $3,500 Average Mileage: 101,000… 2 2: Wipers Activate By Themselves 1999 Ranger Average Cost to Fix: N/A Average Mileage: 91,000 mi 3 3: Shifting Problems 1999 Ranger More

What kind of engine does a Ford Ranger have?

Ford Ranger 3.0L V-6 Engine Displacement (Cubic Inches) 183 CID Block Cast Iron 60º V-6 Type Over-head Valve Engine Bore x Stroke 3.50 x 3.14

How does the a / C work in a Ford Ranger?

The engine is what runs the compressor. If there is enough static pressure (the pressure in the system when the A/C is not running) which is over 75 psi, and the electromagnetic clutch is working, when you turn on the A/C, the clutch will engage the compressor which pressurizes the Refrigerant gas.

How can I service my Ford Ranger air conditioner?

The system on a Ford Ranger can be serviced within a hour, using basic equipment available at most auto part stores. Attach the hose end of the recharge hose to the air conditioning low pressure port. The port is covered by a black dust cap, located on the top of an air conditioning refrigerant line next to the windshield washer fluid filler neck.

Where is the refrigerant line on a Ford Ranger?

Attach the hose end of the recharge hose to the air conditioning low pressure port. The port is covered by a black dust cap, located on the top of an air conditioning refrigerant line next to the windshield washer fluid filler neck. Screw the can of refrigerant to the valve end of the hose.

What’s the best air conditioner for a Ford Ranger?

Another option is the Harbor Freight vacuum pump that hooks up to your shop air compressor.

How to recharge a / C on a Ford Ranger?

You will need a connector from the can to the a/c and a can or 2 of r134a. This will show you how to recharge your ac on a 2002 Ford Ranger 4.0. You will need a connector from the can to the a/c and a can or 2 of r134a. Skip navigation Sign in Search Loading… Close This video is unavailable. The Less Painful Way 15s YouTube Watch later Share

Why is the blend door actuator on my Ford Ranger not working?

The most common symptom of faulty blend door actuator on Ford Ranger is a slight clicking sound repeatedly coming from under the dashboard. The sound will be most prominent for a few seconds when you turn on the air conditioning or adjust the temperature. Sometimes changing the temperature can temporarily stop the sound.

Is it illegal to replace an air conditioner without updating it?

Depending on location, it may be illegal for a technician to replace refrigerant without updating the A/C system to handle the newest type. You may not realize there’s a refrigerant leak until the air conditioner stops blowing cold. Refrigerant may slowly leak out of the system over days, weeks or even years. Read More

Why is my air conditioner not working on my Ford Ranger?

While there are a variety of reasons your Ford Ranger air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.

Why is my Ford Ranger not blowing cold?

These are a few of the most common issues that could cause your Ranger to not blow cold enough. There are other issues that can cause this as well. Most of the time, when your Ranger’s air isn’t blowing cold enough, it is going to be a lack of refrigerant causing the problem.

How much refrigerant does a 1999 Ford Ranger use?

Also, keep in mind that the different years of Rangers use different amounts of refrigerant. The 97 has 25 ounces which is a hair over two 12 ounce cans, where the 94 uses 28 ounces (although I have seen 36 ounces for the 94 as well, but I believe that might be for the R12 version) the 1999 uses 30 ounces.

What to do if your Ford Ranger has no power?

you’re going to have to test for power at the power side of the ac clutch relay. if you have no power you’re going to have to start testing the high and low pressure switches. if you had a gauge set it could be easier to diagnose. Thanks for the link to the wiring diagram.

How can I test my Ford Ranger AC?

it shows the high and low pressure switches in series to a ground then in to the pcm. when the switch opens the pcm shuts the ground off for the relay. you’re going to have to test for power at the power side of the ac clutch relay. if you have no power you’re going to have to start testing the high and low pressure switches.

What are common reasons my Ford Ranger has air conditioning problems?