Should a fuel shut off solenoid get hot?
Should a fuel shut off solenoid get hot?
The fuel solenoid will get hot as it is a magnetic coil. If it overheats it will either drop out and stall the engine or blow the fuse. They will draw around 30amps for a few seconds during startup (pick) then drop to around 2 or 3 when running (hold).
Why is the fuel shut off on my Dodge diesel?
I have a 1997 5.9 cummins dodge diesel the fuel shut off solenoid wont pull up to allow you to start the motor so I replaced the solenoid and still does not pull up when you turn the key on but you can push up manuelly and it will stay up and you can start the motor where do i look for problem is it a relay or some low voltage supply
Why is the fuel pump and relay not working?
The ignition circuit, which includes the ignition switch, controls power to many components, including the fuel pump and relay. If there is an issue with the switch or the circuit, perhaps a wiring problem, then power to the fuel system may be cut off.
When to check the fuel shutdown solenoid relay?
If 12 volts is not present at this circuit when the key is in the CRANK position, check the fuel shutdown solenoid relay. Refer to Relays – Operation/Testing in this section of the group.
Where is the fuel shut off relay located?
It is called the fuel shutdown solenoid relay. The fuel shutdown solenoid relay is located in the engine compartment near the brake master cylinder. It is mounted at the fire wall on a bracket. There are 2 relays there on the same bracket.
I have a 1997 5.9 cummins dodge diesel the fuel shut off solenoid wont pull up to allow you to start the motor so I replaced the solenoid and still does not pull up when you turn the key on but you can push up manuelly and it will stay up and you can start the motor where do i look for problem is it a relay or some low voltage supply
How to fix your fuel shut off solenoid?
FYI the fusible link from Napa is not blue in color, but it is the same one that’s on your truck right now. Blue is just a color that dodge uses and has nothing to do with any other none dodge part you buy at the store, just ask for the 14 gauge fusible link, spend five minutes installing it and your on your way! Hope this helps! arty018:
What kind of Relay does a Cummins diesel use?
I found the relay it has 12.5 volts 3 wire plug at solenoid with key on and 10.80 volts at 10ga red wire when cranking and it still will not pull rod into the solenoid when cranking but I can manually push rod up and it will stay up and run I even bypassed the relay straight from battery and it would not pull rod up I am lost at what to do
It is called the fuel shutdown solenoid relay. The fuel shutdown solenoid relay is located in the engine compartment near the brake master cylinder. It is mounted at the fire wall on a bracket. There are 2 relays there on the same bracket.
