Is the GM part solenoids on a 2012 Malibu?

Wife’s 2012 Malibu had light on for over a year and running bad (I’m ashamed). I decided to go with a GM part solenoids just in case.

What kind of engine does a 2005 Malibu have?

2005 Malibu (Classic, fleet version) with 2.2 L Ecotec four-cylinder engine fails to start. It turns over, and scattered weak pops indicate that there’s rudimentary combustion going on, but it does not catch.

Can a Chevy Malibu 1LT 4 cyl fit?

Fit and worked great on a 2008 Chevy Malibu 1LT 4 cyl Be sure to clean the area around where it goes in, lots of dirt accumulates there and could fall into the solenoid hole which would be bad. THIS IS THE INTAKE SIDE! 5.0 out of 5 stars Make sure! This is for the intake side Item came as expected.

What’s the model number of a GM camshaft actuator?

Make sure this fits by entering your model number. genuine oem factory part; old model number – 12655420; new model number – 12679099 These items are shipped from and sold by different sellers. Show details

How do you remove a camshaft position sensor?

Using a 8mm or 10mm (in most cases) socket or wrench remove the camshaft sensor mounting bolt by turning it counterclockwise. There is usually only one bolt. Sometime these bolts can be over tightened at the factory which causes the bolt threads to stretch and become weak.

How much does it cost to replace a camshaft sensor?

This action causes the engine to loose a small amount of power and fuel economy. Camshaft sensor service costs will vary per manufacturer and depend on the location of the sensor. If you are having the job done at a repair shop or at the dealer it will cost between $180.00 and $250.00 (US).

What happens when a camshaft sensor goes bad?

Symptoms of a Bad Camshaft Sensor. When a cam sensor goes bad it will cause the check engine light to come on and produce a trouble code. It can also cause the engine to run rough while the car is at cruising speed or at idle.

Where is the cam sensor located on a car?

Where is it Located? The cam sensor is located in the valve cover near the top of the engine or they can be located at the front or rear of the cylinder head as in the picture below. When a cam sensor goes bad it will cause the check engine light to come on and produce a trouble code.