Is the 366 GM truck motor a good motor?
Is the 366 GM truck motor a good motor?
Arizona The 366 was a good motor, lots of low end torque and they are not near as bad as a 370 Ford on fuel consumption. I always found their fuel and ignition systems less tempermental than a Ford. Instead of an overhaul you might look into a crate engine from a Chev or GMC dealer. Prices are not too bad and you get a decent warranty.
Where can I find the torque specification guide?
Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life. Under torque of an axle nut will allow excessive movement causing uneven loading and excessive wear.
What are the differential set up specifications for a Dana?
Differential Set-Up Specifications DANA 28 10-13 5-6 55 50 DANA 30 12-15 6-8 55 60 DANA 30 JK 12-15 6-8 80 60 DANA 30 JL 15-20 8-12 70 70
What happens if your spindle nut is over torque?
It will also leave your spindle nut under or over torque resulting in hub assembly failure. Ensure that you have the correct torque for the application by referring to SKF 457377 torque specification guide or contact the vehicle manufactures dealer. It is important that you properly torque the spindle nut to ensure optimum bearing life.
Arizona The 366 was a good motor, lots of low end torque and they are not near as bad as a 370 Ford on fuel consumption. I always found their fuel and ignition systems less tempermental than a Ford. Instead of an overhaul you might look into a crate engine from a Chev or GMC dealer. Prices are not too bad and you get a decent warranty.
What are torque specs for small block Chevy?
These specs are for stock-type bolts with light engine oil applied to the threads and the underside of the bolt head. Moly and other lubes offer reduced friction and increased bolt tension, which will affect the torque figure. If you use aftermarket performance bolts like ARP’s, you should follow the recommended torque specifications.
Where can I find the latest torque specs?
Find the most up-to-date torque spec listings in electronic format. FelPro-Only.com is your convenient source for advanced sealing information. It’s the place to learn and share “tricks of the trade,” find proper diagnosis and installation instructions, and enjoy easy access to parts reference.
Is there a 366 motor in a GMC 7000?
We recently bought a GMC 7000 off of Ebay and it has a worn out 366 in and we’re tossing around the idea of either rebuilding this motor or finding a rebuildable 427. I’d like to slip a small diesel in it’s place but we don’t want to spend 20 grand on a 2 grand truck.
