Is Kidde model KN COSM BA recalled?

Is Kidde model KN COSM BA recalled?

The recall involves the Kidde NightHawk talking combo smoke/CO alarm with model number KN-COSM-IB and manufacture dates between June 1, 2004 and December 31, 2010. Alarms are hard wired into a home’s electric power. Consumers should stop using the alarms immediately and contact Kidde for a free replacement.

Where is model number on Kidde smoke detector?

back label
The model number is located on the back label on your alarm. If you look at the back of the alarm, you will see the name of the product and the model number in bold text below the logo.

How long does a Kidde combo smoke CO alarm last?

seven to ten years
In accordance with the National Fire Protection Association (NFPA), Kidde recommends replacing smoke and heat alarms every ten years, and replacing carbon monoxide and combination alarms every seven to ten years (depending on your model) to benefit from the latest technology upgrades.

How do I reset my Kidde combo smoke CO alarm?

Resetting the Alarm

1. Turn off the power to the smoke alarm at the circuit breaker.
2. Remove the smoke alarm from the mounting bracket and disconnect the power.
3. Remove the battery.
4. Press and hold the test button for at least 15 seconds.
5. Reconnect the power and reinstall the battery.

Are Kidde smoke alarms good?

Best Overall: Kidde Battery-Operated Combination Smoke/Carbon Monoxide Alarm with Voice Warning. There are plenty of great smoke detectors on the market, but this combo unit from Kidde sets the bar for ease of install, superior detection, and multi-type alerts.

What Kidde model do I have?

The model number will be located on the label in the bottom right or left hand corner. It will say MODEL before it and give you a list of models. For Smoke and CO Alarms: The model number is located on the back label on your alarm. To find it you’ll need to remove your alarm from the ceiling or wall.

How can I tell how old my smoke detector is?

Check the date Look on the back of the device for the date of manufacture. Remember that smoke detectors should be replaced 10 years from the date of manufacture. If it’s less than 10 years old, put the smoke detector back on the ceiling or wall.

Do Kidde smoke detectors expire?

Replace and upgrade your smoke alarms every ten years. Smoke and carbon monoxide alarms must be replaced within the specified lifetime of the product, usually 5 to 10 years after the date of manufacture.

How do you turn off a hardwired smoke detector?

Hardwired

1. Disconnect the alarm and remove its battery.
2. Holding the alarm by its edge, use a keyboard cleaner to remove debris on the side of the device.
3. Press and hold the test button for five seconds.
4. Reconnect the device to power and its backup battery. It will chirp once it connects to power.

How do you turn off a Kidde smoke alarm?

To Deactivate Your Alarm: Break through label with a screwdriver. Turn the screw to the “OFF” location. This will deactivate the alarm, stop the low battery chirp and render the alarm safe for disposal by draining the battery.

What to do if Carbon Monoxide alarm?

What to do if your carbon monoxide detector alarm goes off. If you hear you carbon monoxide detector going off at any point, you should immediately do the following: Turn off any appliances that could be the source of carbon monoxide. Open doors and windows to let fresh air into your home. Check everyone in your home is awake and accounted for.

Why is my Carbon Monoxide alarm beeping or chirping?

The most obvious reason for a beeping carbon monoxide detector is flat batteries. Flat or low batteries will hinder the functionality of the device, so it’s only fitting that your detector gives off a faint beeping sound to warn you of this.

How do smoke and carbon monoxide detectors work?

With a metal oxide semiconductor detector, a small silica chip is what interacts with carbon monoxide in the atmosphere. This interaction causes a drop in the current flowing through the chip, similarly to the way ionization smoke detectors work. When the voltage drops, the alarm sounds.