How to turn off the fine swing control on an excavator?
How to turn off the fine swing control on an excavator?
Push down on the left side of the switch in order to turn off the fine swing control. Operate the machine with the switch in the OFF position when great swing forces are required. For example, digging on a sidewall requires great swing force.
When to use the swing brake on an excavator?
Operate the machine with the switch in the OFF position when great swing forces are required. For example, digging on a sidewall requires great swing force. Operate the machine with the switch in the OFF position in order to control the motion with the swing brake. The purple wire gets voltage from the fine swing fuse.
Why does my excavator not swing in either direction?
The rear solenoid had no power on either wire. At full throttle on right console left switch down and right switch held up lights flash on panel, while doing this moving the swing lever in either direction I can feel it bump each time the lights flash. The machine still does not swing. Any suggestions? I did miss a step for you to test.
Why did my John Deere mower stop after 15 minutes?
When I called to let her know that I had arrived, she told me the John Deere rider had stopped after about 15 minutes and she had to get the neighbors to help push it back to the house. From her description, we agreed that it was either a fuel or air problem.
Is there an excavator that does not swing?
yes this is the only function that does not work. Yes the large lines do get tight with pressure with i try to swing. Yes we have removed the motor from the drive gear and the machine can be pushed around while it is removed. The smallest lines are for swing brake. It will connect to a solenoid to control it. Check for power to the solenoid.
Operate the machine with the switch in the OFF position when great swing forces are required. For example, digging on a sidewall requires great swing force. Operate the machine with the switch in the OFF position in order to control the motion with the swing brake. The purple wire gets voltage from the fine swing fuse.
Are there any problems with a Hitachi excavator?
Discussion in ‘ Excavators ‘ started by Aaron Prasad, Mar 3, 2013 . Hi, my father had bought a Hitachi EX200-2 excavator and from the very start we have had problems with it. The machine has a Manual regulator installed so it’s a manual machine now and all the electrical wires that were present before has been removed before we bought it.
What to do if your excavator is black?
If it is black then you are on the brake solenoid. Testing can be done with the key ON and the BACK-UP switch UP. The left switch is back-up and right switch is throttle. Check green wire for 24v and black wire for continuity to ground.
Where are the solenoids on a 322bl excavator?
A K906 green wire is the control from the ECM, this wire runs through the back-up mode switch (K907 green) located in the rear of the right hand console. This switch can be placed in back-up mode to test the solenoid also. Try it in back-up and see if brake releases. Your model should have two solenoids.
