How to solve Ford Passive Anti Theft System PATS trouble?

There is no communications with PCM ; PCM will always communicate on the diagnostic link regardless of theft status. (Investigate PCM system) Engine stalls on road: Once the engine runs for one second, PATS CANNOT disable the engine. Running stalls are not PATS issues.

Where is the anti theft indicator on a Ford Escape?

Note: Do not leave a duplicate coded key in the vehicle. Always take your keys and lock all doors when leaving the vehicle. The anti-theft indicator is located in the instrument panel cluster.

How many keys are in Ford anti theft system?

B1213: Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 :Transceiver internal antenna damaged.

What happens if you touch the IKT on a Ford Escape?

You need to prevent these objects from touching the coded IKT while starting the engine. These objects will not cause damage to the coded IKT, but may cause a momentary issue if they are too close to the IKT when starting the engine.

How to turn off the anti theft system on a Ford Escape?

On a ford escape remove positive cable from battery, place key in car and turn to the on position, then replace positive cable, turn key off then back on to reset anti theft system. Worked on 2005 escape! Thank you so much! I followed the advice from Jay. C and this just worked for me.

Where is the anti theft light on a Ford?

The display of the car behind the steering will light up and will show the anti-theft light blinking or constantly lit. Leave the key in this position for at least 10 minutes. Check the anti-theft light again.

If you are interest in Launch X431,here is a articles collection: How to use LaunchX431, and for more about Ford topics,check here: Ford Repair Projects B1213: Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 :Transceiver internal antenna damaged. Replace transceiver.

What kind of security system does a Ford have?

The most common security system is PATS. Pats is a system that automatically detects whether you have the original key to start up the engine or some cheap key from Walmart. The system initially started to make its way into Ford vehicles around 1996. From there, the system was added to many more Ford vehicles.

When did Ford start using the PATS system?

The system initially started to make its way into Ford vehicles around 1996. From there, the system was added to many more Ford vehicles. Losing the original key means you no longer have access to the car. You may open the doors, but the engine won’t start regardless of how often you turn the key to the on position.

What to do if you lose your Ford Pats key?

If you’re out of luck and lost your transponder key and can’t start up the car, you will have to get a new key. This is when you learn how to disable Ford pats system PAT2. The key itself is ridiculously cheap. However, if you have someone set it up, that’s when the price goes up.

How to relearn Ford Passive Anti-Theft System ( PATS )?

Replacing PCM only — A or D type PATS If only the PCM is being replaced on a PATS control function type A or D vehicle, no relearn is required (please refer to the Ford PATS chart to determine PATS type). Simply put the original key in the ignition, turn to ON or RUN and wait for 20 seconds. Then turn the key off and start vehicle.

What are the trouble codes for Ford Pats?

Most of the PATS trouble codes are body “B” or data “U” type codes. You must have a code reader that can read these codes. Repairing a PATS system is NOT hard. B1213 Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 Transceiver internal antenna damaged. Replace transceiver.

How to reset the anti theft system in a Ford?

1 Insert the key into the ignition and turn it on to the position where the accessories are activated but not the engine. 2 Leave the key in this position for at least 10 minutes. 3 Check the anti-theft light again. 4 Now try to start the engine. 5 Repeat the process at least a couple of times if it does not work the first time.

Are there any PATs related ECU’s that are defective?

ECU is defective (EEPROM in PCM is not working – replace PCM). PATS related when stored in PCM only. B1600 B10D7-87 Non-PATS Key or damaged key. B1601 B10D7-51 Unprogrammed encoded ignition key detected (leave ignition on for 20 seconds before trying a programmed key, in Anti-Scan Mode) B1602 B10D7-8F Particial detection of encoded ignition key.

Is there a theft alarm on a Ford Expedition?

The passive anti-theft system (PATS) is installed on every Ford Expedition at the factory. While some erroneously call this system the factory alarm, it really is not an alarm system. The PATS system will arm itself if someone attempts to start the vehicle with anything other than the PATS key programmed to that specific vehicle.

Can you use a non Pats key on a Ford Expedition?

If you use a non PATS key, such as one that was cut simply to open the doors from an all-metal key blank, the system will remain armed. If the Expedition starts, then you have disarmed the PATS system. If not, move on to step 2. Verify you have the right key. Ford PATS keys have large black plastic, or molded rubber, heads.

How to relearn Ford Pats control function module?

Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.

Is it possible to bypass the Ford PATS system?

We’ll walk you through the steps you need to bypass the Ford pats system. Before we get started, you should know that the following steps should not be a permanent solution; doing so will leave your car unprotected against possible car thieves. You should only bypass the ford pats system temporarily until you get a new transponder key.

B1213: Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 :Transceiver internal antenna damaged.

How to disengage anti theft system in Ford?

You can turn off Ford anti theft by following these steps: First step is removing positive cable from battery in order to place key in automobile safely. Second step is to turn the “on” position then replace the positive cable. Last step, drivers need to turn the key off and on in order to reset the anti theft system.

How often does the Pats theft indicator flash?

PATS Theft Indicator flashes every 2 seconds at Ignition OFF. This is normal operation for PATS to act as a visual theft deterrent. (See chart on reverse side for applicable system.) PATS Theft Indicator stays on for 2 or 3 seconds (depending on system type) at Ignition RUN or START and then off. This is normal operation for PATS prove out.

What to do if your anti theft system is locked up?

If the anti-theft system has locked up your engine, you won’t be able to start it. You’ll have to disable it with these steps. Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position.

Can a PATS system cause an alarm to go off?

PATS will not cause the alarm to go off. Remote Entry/Keyless Entry problems: PATS is completely separate from the Remote Entry/Keyless Entry systems. There is a no-crank problem on vehicles without PATS starter disable. Check Table 1, for presence of Starter Interrupt.

How to disable anti theft in vehicles ( Pats )?

Press the unlock button on your vehicle’s key fob to deactivate the alarm. If you’ve misplaced your remote for the car, use the PATS programmed key to unlock the driver’s side door. Then, put the key in the ignition and turn the key to the “on” position. The vehicle’s battery should be on, but the engine shouldn’t be running.

Can a thief bypass one anti theft system?

If one can bypass one Ford, they can bypass all, thereby taking a stupid argument from the day that a thief would not spend thousands on a key programmer to make a key for one vehicle. Even back when the cost was thousands]

Why is my anti theft system not working?

It’s possible that the anti-theft system in your car won’t function correctly at some point. This may be for many reasons including a dead car battery that loses its key memory or a dead battery in your remote. It could also be that your immobilizer chip is damaged in your key or the car door lock is damaged.

How to solve Ford Passive Anti Theft System PATS trouble?