How to reset the tire pressure monitor on the 2007 Chevy?
How to reset the tire pressure monitor on the 2007 Chevy?
Remove the air chuck from the valve stem and recheck the pressure in the tire. Repeat Steps 5 and 6 until the tire pressure is within 2 psi of the recommended pressure. Repeat Steps 5 through 7 on to adjust the pressure on any other tires that require additional air.
What is the service tire monitor light on a Chevy Silverado?
This article applies to the Chevrolet Silverado 1500 (1999-2006). The service tire monitor light is a warning bulb connected with the TPMS or Tire Pressure Monitor System, which notifies the driver of low or high air pressure in the tires.
How to reset the TPMs on a 2007 Chevy Silverado?
There are two reset procedures for the 2007 Silverado’s TPMS. The first, and most common, procedure is to adjust the tire pressure if it is low. The second procedure is to relearn the position of each sensor, which you only need to do if you have rotated the tires or replaced a sensor.
Why is my service tire monitor light stuck?
Common causes of a stuck light include damaged TPMS sensors and incorrect tire pressure. However, some cases may only require the tire pressure system to just be reset.
How to reset tire pressure sensor on Chevy Silverado?
If your vehicle has the DIC buttons, press the set/reset button. The horn will sound twice to indicate the TPMS receiver is ready, and the TIRE LEARNING ACTIVE message will display.
How do you reset the TPMs on a Chevy?
Turn ignition to the ON/RUN position with the engine OFF (not the ACC position) and lower the driver’s side window. 3. Press the Vehicle Information button (located to the left or right of the instrument cluster) repeatedly until “LEARN TIRE PRESSURES” is displayed.
How to reset Chevy Silverado 1500 emission monitors?
Do not brake or shift in order to slow down. It is important to let your Silverado coast along gradually slowing down to 20 mph. The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims. F. Accelerate: Accelerate again at 3/4 throttle until 55-60 mph is reached.
How to run a secondary air monitor on a Chevy Silverado?
1. Idle vehicle 5 minutes (achieve closed loop) 2. Accelerate and drive for 1 min at steady speed above 50 mph 3. Slow vehicle down to 20 mph. Do not use brake clutch, or shift gears. 4. Repeat steps two and three 5 times.
