How to remove rear axle hub and axle?
How to remove rear axle hub and axle?
Remove the 2 bolts and disconnect the shock absorber with bracket from the axle carrier. Remove the 4 bolts, and axle hub and the bearing from the axle carrier. Do not place the hub and bearing’s magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
Is the front hub the same width as the rear hub?
At 100mm the front hub is the same width as traditional wheels. The rear is different though and will either be 135mm for a QR axle or 142mm for a thru axle wheel. While some disc brake wheels use traditional QR axles, many now use bolt-through (thru) axles.
What kind of bolts do I need to replace wheel hub?
The four bolts you are removing may be 12mm Triple-square bolts. In the event that your T60 Torx does not work, use a 12mm Triple-square. It is now time to install the new hub assembly. Bolt the assembly in first, following a “cross” pattern as you tighten the bolts.
What to do if your rear axle nut is damaged?
Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged. While applying the brake, remove the lock axle hub nut. Remove the 2 bolts and disconnect the shock absorber with bracket from the axle carrier.
How to replace rear wheel bearing hub assembly?
Screw the two M8×1.25 bolts into the holes in the drum brake to push it away from the hub. It may be rusted to the hub so prepare for some cracking sounds. Remove the drum once it is free 8. Remove the four 12mm bolts on the back of the hub.
How to replace rear automotive axle bearings 1 ton?
Before you begin, park your car on level ground with the transmission in park. You will need to raise up your car with a floor jack and secure it using jack stands for safety and then remove and reinstall the wheel. Remember safety first, never get under the vehicle unless jack stands are in place.
What should I do after replacing my rear axle?
After the axle has been reinstalled use a gasket scraper to remove the old gasket and clean the differential surface. Make sure this surface is clean from gear oil or it will contaminate the sealer and possibly cause a leak. Use a shop towel to wipe out the inner differential housing to help control additional oil.
How do you replace the pivot pin on a rear axle?
The pivot pin will need to be replaced along with the bolt. Once the pivot bolt has been removed, reach your hand down around to the bottom of the carrier and use your finger to pop the pin upward while grabbing it with your other hand.
