How to power a no power to wire harness?
How to power a no power to wire harness?
Connect the white wire in the gray housing to the blue wire under the hood with a Zinc Plated Hex Flange Nut – M8, part # 185917. Connect the black wire to the auxiliary positive post. A 40 amp fuse will need to be placed in the last spot on the fuse box, closest to the post, to power the hot lead (see picture on the link below, step F.)
Do you have no power to wire harness for trailer brakes?
I have no power to the wire harness for the trailer brakes There are a few things you will need to do under the hood of your 2004 Chevy Silverado before you will have power at the wiring harness. You will need to remove the bracket in the corner closest to the driver (see pic step A on the link below that I attached).
How to routing power wire for a trailer?
After routing the wire, seal the hole with silicone sealant to keep out moisture and exhaust fumes. Once the wire is under the vehicle you will simply follow along an existing factory wiring harness or the frame rail toward the front of the vehicle or to where the battery is located.
Where is the power to wire harness located?
A 40 amp fuse will need to be placed in the last spot on the fuse box, closest to the post, to power the hot lead (see picture on the link below, step F.) Once these connections are made, you will need to run the double bonded wire to the back of the vehicle, where it will be attached to the 6 or 7 way adapter.
Why does my trailer have no power to stud 2?
Stud 2 on my truck is what the trailer shop said to use but it has no power and I don’t know why. Fuse seems fine, correct fuse spot according to fuse diagram, power to both sides of fuse, but no power to Stud 2. I can use Stud 1 for the trailer but it bugs me that there is a stud that apparently should have power and doesn’t.
Why is my trailer not getting any power?
If you aren’t getting any power on the wires going into the connector, then the connector itself isn’t the issue. There’s something going on with the factory trailer wiring. Since all the fuses are good there’s likely a short somewhere on the wiring.
Why is my 7 way trailer not connected?
It can sense when a trailer is connected based on the voltage draw so it won’t sent a signal for 12V when using some testers, especially LED testers because there isn’t enough of a power draw. The system requires a power draw on the 7-way and then holding the brake pedal for about 3 seconds until your dash registers “trailer connected”.
Why is my truck not getting 12V power?
Since you are not getting the 12V power when your truck is running, you most likely don’t have a fuse issue as you stated their isn’t a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the 7-way.
