Easy lifehacks

How to permanently disable the PassLock II system?

How to permanently disable the PassLock II system?

Try restarting it, you will see the red security light on, but that can be removed with the LED mod how to. This can also be done using this Bypass (this is what is done on my 2007 Cobalt ss/sc for the remote start/alarm). Thanks for the how to but with an HPtuners you can disable it with out going through all that.

What happens if I disable PassLock on my car?

If your car is stalled and you cannot start it again because of the PassLock security system, do not try to start it again and again, because it can drained your battery, and it will be difficult to start it again, even if you are able to disable the lock system.

How to disable GM PassLock system step by step?

The process is simple but if you try too much force with it, it will cause you some serious inconvenience and a process, which can easily be performed and done, will become quite difficult and time consuming. You can disable GM PassLock system by performing some simple steps.

What to do if your PassLock is locked?

Instead concentrate on basic instructions and you will be able to start your journey again without much delay and hassle. Turn on the ignition key and leave it at ‘ON’ position, after the vehicle stalls. This is to turn on the PassLock security system to see if it is locked.

How can I disable the PassLock system on my car?

Look at the dashboard and locate the theft system light. It will be blinking on and off. Wait for 10 to 15 minutes until the light stops flashing and stays on. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

Is there a way to bypass PassLock 2?

The easiest way to bypass the Passlock 2 system is to place a resistor between the passlock sensing wire and the ground reference wire. To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black.

How to permanently disable GM PassLock system Hilux Motors?

5.Take your digital ohm meter and put your negative probe on the black wire that you stripped back earlier. Put the positive probe on the yellow end of the wire that leads BACK to the ignition. Use alligator clips here to help the probes grab the wires. 6.With the probes hooked up turn the ignition to the run position.

Instead concentrate on basic instructions and you will be able to start your journey again without much delay and hassle. Turn on the ignition key and leave it at ‘ON’ position, after the vehicle stalls. This is to turn on the PassLock security system to see if it is locked.

Author Image
Ruth Doyle