How to change the brakes on a Dodge Ram?

How to change the brakes on a Dodge Ram?

1 Elevate the vehicle off the ground. Loosen the lug nuts on the wheels before jacking up the truck. 2 Remove wheels. Now that the vehicle is elevated, you can remove the wheels where you will be changing the brakes. 3 Depress piston on caliper. 4 Wash down brakes. 5 Remove brake caliper.

How does the brake fluid work on a Dodge Ram?

Pressing the brake pedal applies pressure to push the master cylinder piston forward, and transfers the brake fluid to each of the four brakes via the brake lines. The fluid then pushes on the caliper pistons as well as wheel cylinder pistons to place the brake pads and shoes in contact with the rotors and drums, thus stopping the vehicle.

Where does a leaking brake caliper go on a Dodge Ram?

A leaking brake caliper is easily spotted since the caliper body is exposed inside of the wheel and will be wet with fluid. A severely leaking wheel cylinder on the rear drum brakes will often leave a wet puddle down the rear side of the backing plate, or the bottom of the brake drum.

Do you need to replace the master cylinder in a Dodge Ram?

There are many other parts in a Dodge Ram’s brake system that require replacement or overhaul after many miles. One of these parts is the brake master cylinder. As you depress the brake pedal you actuate a piston that is sealed inside a metal cylinder.

How do you remove the caliper from a Dodge Ram?

To completely remove the caliper, you will need to loosen the banjo bolt that secures the rubber brake line to the caliper (Figure 7). This will be the only thing keeping it attached to the vehicle at this time. When you loosen this bolt, brake fluid will leak out, so be prepared to catch it with a suitable container.

Do you need to break in New brake pads?

Having new brake pads and rotors installed happens on a regular basis. Once those brake pads and rotors are mounted, it is essential to properly break them in. Bedding in, commonly known as breaking in, new brake pads and rotors is necessary for new brakes to work properly.

What to do if your rear brakes are not working?

Any electrical faults in the rear ABS system are generally indicated with a light illuminated and if so, then the flash codes can be read out. But with no light illuminated then there most likely no electrical failures in the system.