How to change fuel pump in 1998 Chevy S10?

36 people found this helpful. Change fuel pump change regulator relay switch is good pour gas in the intake and nothing happens at all either what is it 1998 chevy s10 pick up 4.3 v6 6 people found this helpful. Check for spark. Make sure all fuses and relays are good.

Why does my Chevy S-10 not start up?

Once the truck starts and is running you can remove the jumper to the fuel pump and it will continue to run. The only thing i can think of is that you are not getting the priming signal to the fuel pump, that the ECM if faulty. It turns over fine.

What to do if your S10 cranks won’t start?

(I know this is an old thread) Cranks but no start, added gas, still no start. Poured gas into intake, fired and ran until gas ran out. Bought fuel pressure tester, tested at 45 on rail but bled to zero in less than a minute. Bought fuel pump and pressure regulator to replace.

What should I do about my 1998 Chevy S10?

Change fuel pump change regulator relay switch is good pour gas in the intake and nothing happens at all either what is it 1998 chevy s10 pick up 4.3 v6 6 people found this helpful. Check for spark. Make sure all fuses and relays are good. When was your last tune up?

What to do if your fuel pump wont start?

For future reference, I had this same problem when replacing the fuel pump on my 2002 s10 4.3L. Searched forever for an answer. It turns out that in order to remove the bed of the truck, you must disconnect the ground for the fuel pump, which attaches in the rear on the drivers side.

Why does my 1994 Chevy S-10 not start?

1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.

What kind of engine does a 97 Chevy S10 have?

I have a 97 2.2 liter s10 gets gas good spark but wont crank 13 people found this helpful. I have a 97 Chevy s10 4 cylinder, truck stalled on me while on the highway, had it towed to a shop i always go to, they did an inspection and tell me its the timing chain, and engine needs to be taken out or replaced.

Why does my fuel pump not start when I change it?

You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start. Another problem you could be having is spark.

What happens when the fuel pump goes out on a Chevy S10?

There are physical signs that you can feel when your S10’s fuel pump is going out. Before taking anything apart, check to see if your engine’s computer has any trouble codes saved in it. The engine may throw a P0087 trouble code. This trouble code detects that the fuel rail/system pressure is too low.

Where is the fuel filter on a 1999 Chevy’s 10?

The fuel filter is located on the driver side, under the front corner of the bed near the inner frame. At least in my 1999 S 10 4 Cylinder. And how to do it is on this link http://www.2carpros.com/how_to/how_to_change_fuel_filter.htm Hope that helps. I have bought a Fuel filter and going to put that on.

What causes a Chevy S10 to not start?

Often it’ll be bad spark plugs, or a bad coil pack. If the fuel pump has completely failed, the engine won’t start at all. At the most basic of levels your Chevy S10 needs three things to start: Air, fuel, and spark . If any of these things aren’t present, the engine won’t turn over at all.

How to change fuel pump in 1998 Chevy S10?