How to adjust the ignition of a 235 engine?
How to adjust the ignition of a 235 engine?
The steel ball is the right timing mark, and make sure you have ported vacuum to your vacuum advance, when you open the throttle the distributor should turn and advance the ignition. Set your point dwell between 28-32. Set the point dwell first then the timing. dwell changes timing, timing don’t change dwell.
What kind of timing light do I need for a Chevy 235?
I have a 53 chevy truck with a 58 235 motor, its running really rough and i want to recheck the timing with a timing light. What mark do i use from the flywheel?
How do you set the timing on a 54 6 cyl 235 CI?
See the USA in your Chevrolet! You do not say what year 235, that would help a lot. I am familiar only with the stuff up to 54 but those engines are timed in the same manner as the earlier 216s, there is a BB in the fly wheel which is the timing mark.
Where is the timing mark on a Chevy flywheel?
Not sure where you expect to see the timing mark on the OD of the flywheel. The mark is on the front face of the flywheel and the only place you can see it is through a hole in the bellhousing just above the starter. The firing order is 153624 with 1 being at the front of the engine.
The steel ball is the right timing mark, and make sure you have ported vacuum to your vacuum advance, when you open the throttle the distributor should turn and advance the ignition. Set your point dwell between 28-32. Set the point dwell first then the timing. dwell changes timing, timing don’t change dwell.
How do you change the timing on a 235?
To adjust the timing by vacuum , loop the gauge over the rockerbox where you can see it from the right side and loosen the dizzy’s pinch clamp a teense , rotate the dizzy _counterclockwise_ (advancing the timing) and watch the gauge ~ it will rise in vacuum as the engine picks up speed but after a bit the needle will begin…
I have a 53 chevy truck with a 58 235 motor, its running really rough and i want to recheck the timing with a timing light. What mark do i use from the flywheel?
What’s the best rpm for a 235 engine?
Actually , it’ll run best with 33° dwell . The pressed in BB is for ignition timing and the engine *must* be idling at or below 600 RPM’s when setting the timing . Cehck to ensure you have no vacuum to the dizzy when it is idling ! this is critial .
