How much fluid does a 208 transfer case hold?
How much fluid does a 208 transfer case hold?
RE: NP-208 fluid capacity The type of fluid should just be regular ATF. Your looking at somewhere around 4.5 quarts (9 pints) of fluid to fully fill an NP208 transfer case.
Is the Process 208 transfer case for four wheel drive?
The New Process 208 transfer case has seen use in four-wheel-drive trucks from all of Detroit’s Big Three at one point or another, making for some odd bedfellows where parts interchanges are concerned. The transfer case “increases the ratio of engine revolutions opposed to tire revolutions.”.
When did Ford start using the np208d transfer case?
Dodge used the NP208D in the D series from 1982-1987 and Ford installed the NP208 from 1980 to 1986 in full sized Bronco’s, F250 and F350. Below we offer quality transfer case parts and rebuild parts kits that are designed to be top of the line overhaul kits.
Is the transfer case on the F-150 the same as the F 250?
Both the Ford F-150 and F-250’s engines have similar transfer case setups even though their transmissions are different. The process for removal and installation is the same, however. Always remove the battery terminals before starting any work.
Which is NP208 transfer case is the best?
The New Process NP208 transfer case is a strong, reliable unit that features 2.69:1 low range, chain driven aluminum case and is a lot lighter then other cast iron case of the time. The output drop for the front driveshaft is on the drivers side. Give us a call 800-216-1632 and let us help save you some money, ask about used parts.
When did Ford start using the NP208 transfer case?
Ford used 31 splines in 1981-1986 Broncos, F250 and F350 pickup trucks. GM used this transfer case in Pickups and Suburbans between 1981 and 1986 typically behind automatics with 27 splines. Cherokees and J trucks used this unit between 1980 to 1988 and called it the Command Trac. The NP208 is widely used because of its strength and weight.
What kind of transfer case is New Process 208?
The New Process 208 is a chain-driven transfer case. This is a cast aluminum transfer case. Compared to the NP203 and NP205, the light-weight cast aluminum housing of this transfer case is easier to handle.
Is there a warranty on the NP 208 transfer case?
If you decide to replace your NP 208 transfer case with a re-manufactured unit with a 12 month unlimited mileage warranty. Please see our complete list of transfer cases for Chevrolet/GMC, Dodge, Ford and Jeep vehicles.
When was the Dana 20 transfer case made?
The Ford Dana 20 transfer case is gear driven with a cast iron case. It was used in early Broncos from 1966 until 1977 and it was used in some Ford pickups. It is drivers drop and it was available with a couple different low range ratios.
