How many quarts does a 1993 Ford Ranger take?

How many quarts does a 1993 Ford Ranger take?

5 quarts
Capacity: 5 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.

What kind of oil does a Ford Ranger use?

Changing the gear oil in a 1987 Ford Ranger 5 speed transmission, 2 wheel drive. The first gen MANUAL transmission Rangers with either a MAZDA or MITSUBISHI 5 speed spec for Ford part # D8DZ-19C547-A with specification ESP-M2C83-C which is 75W90 GEAR OIL.. Consult your service manual for the type of trans fluid your vehicle requires.

What kind of transmission does a Ford Ranger have?

Transmission options included four-speed manuals and three-speed auto, with the five-speed manual and four-speed variants coming in later years. Because of strong competition and conservative appearance, initial sales of the new Ranger were slow.

How big is the repair manual for a Ford Ranger?

1996-1999 Ford Vehicles Workshop Repair Service Manual (2.9GB DVD IMAGE!) 1996-1999 Ford Vehicles Workshop Repair Service Manual (2.9GB DVD IMAGE!) Ford AeroStar Aeromax Cargo Econoline Expedition Explorer F&B Series F-150 F-250 F-350 Super Duty Louisville L-Series Mountaineer Ranger Villager Windstar 1997 Service Repair Workshop Manual Downl

How to change manual transmission fluid in Ford F150?

Make sure you close the drain plug, then using your fluid pump, pump fresh fluid into your fill hole until it overflows. It should take about three quarts of automatic transmission fluid (ATF). Once the fluid overflows, tighten the fill plug and clean the area. Figure 3. Pump fresh fluid until overflows.

How do you change the oil in a Ford Ranger?

For most Fords, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Ford Ranger oil filter wrench. If your Ranger is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Ranger.

What kind of transmission plug do I need for a Ford Ranger?

You should replace the rubber plug with a steel Dorman cup plug P/N 555-108 or Dana P/N 219-3052. You will need 3 plugs. These transmissions often melt down due to the oil loss caused by these plugs. Many owners have went with synthetic transmission fluid hoping to extend the life of the transmission.

What kind of oil does a 1987 Ford Ranger use?

Please try again later. Changing the gear oil in a 1987 Ford Ranger 5 speed transmission, 2 wheel drive. The first gen MANUAL transmission Rangers with either a MAZDA or MITSUBISHI 5 speed spec for Ford part # D8DZ-19C547-A with specification ESP-M2C83-C which is 75W90 GEAR OIL..

How much fluid does a Ford Ranger need?

Need to know what type of fluid your Ford Ranger needs? 3.0 quarts (drain and refill) / 6.0 quarts with torque converter drain. Add more fluid as needed, 1/2 pint at a time. 3.0 quarts (drain and refill) / 6.0 quarts with torque converterdrain. Add more fluid as needed, 1/2 pint at a time.