How long to wait for vats code on Corvette?
How long to wait for vats code on Corvette?
Remember to wait at least 4 minutes between each cycle. Once you have found the VATS Code for your Corvette, you can use it to order the appropriate key blank. After ordering the key blank, you must bring it to a local locksmith to get the key cut to match your ignition lock.
How many ohms are in a corvette vats key?
OPTION A: If you have a working VATS key… VATS Code Ohms Resistance Value #4 0.887k (887) #5 1.130k (1,130) #6 1.470k (1,470) #7 1.870k (1,870)
What does p2534 mean on an ignition switch?
P2534 is a diagnostic trouble code (DTC) for “Ignition Switch Run/Start Position Circuit Low”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
When to remove resistor from Corvette vats plug?
If the Corvette starts, your VATS Code is #1 and you are done! If it does not start, YOU MUST WAIT 4 MINUTES before trying resistor #2. You can wait more than 4 minutes, but no less than 4 minutes. After 4 minutes, remove resistor #1 from the plug and start again at Step 3. However, this time use resistor #2.
Remember to wait at least 4 minutes between each cycle. Once you have found the VATS Code for your Corvette, you can use it to order the appropriate key blank. After ordering the key blank, you must bring it to a local locksmith to get the key cut to match your ignition lock.
What are the trouble codes for a corvette?
31 LCD data circuit shorted to battery or CCM internal open 33 Data clock circuit shorted to battery or CCM internal open circuit 35 Data strobe circuit shorted to battery or CCM internal open circuit 36 Data strobe circuit open or shorted to ground 37 M clock circuit shorted to battery or CCM internal open circuit
Where are the ECM and CCM codes on a corvette?
1990-1993 Corvette ECM and CCM codes can be accessed placing a jumper wire in ALDL positions A and G. Position A is in the top right corner; position G is the first position at the lower left of the ALDL. 1994-1996 Corvette ECM, CCM and ASR/EBTCM codes are accessed placing the jumper wire in ALDL connector positions 4 and 12.
P2534 is a diagnostic trouble code (DTC) for “Ignition Switch Run/Start Position Circuit Low”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
