How long does an EVAP test take?

It says the EVAP & Seconday AIr System monitors are not ready. A complete driving cycle will perform diagnostics on all monitored systems and can usually be completed in less than fifteen minutes.

What’s the diagnostic code for a s 10 engine?

F for at least 4 seconds after the engine had been running for 2 seconds. 16 – System voltage high – Charging system voltage was either below 9 volts or above 17 volts for 10 seconds.

How do you pass the OBD-2 emissions test?

To pass an OBD-II emissions test, a vehicle must: If you clear the ‘Check Engine’ light, or reset the OBD-II monitors right before your emissions test, your vehicle typically will not pass because the catalyst and EVAP monitors need time to run.

What should the coolant temperature be in a Chevy S-10?

A. Cold Start: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Ensure your Chevy S-10’s fuel tank is between 1/4 and 3/4 full. Engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.

What are the different types of OBDII monitors?

These are the “non-continuous” monitors and include the catalytic converter efficiency monitor, the evaporative system monitor that detects fuel vapor leaks in the fuel system, the EGR system monitors, the secondary air system monitor (if the vehicle has such a system), and the oxygen sensor monitors.

Where is my OBD2 port on my Chevy S-10?

OBD2 port Chevrolet S-10 (1994 – 2004) – Find your plug ! Where is my OBD2 port ? All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case.

Can a secondary air injection monitor be set?

It’s not a guarantee that the injection monitor will set, but it’s at least an indication that the secondary air injection system is at least functioning at the most minimal level and not triggering any air injection trouble codes.

What does disabled mean on OBD2 readiness monitor?

It means that the OBD2 system has not been able to run this routine or it has failed. OBD Auto Doctor indicates this by red exclamation mark. Disabled meaning that the test has been disabled for the rest of this monitoring cycle. A monitor can be disabled when there is no easy way for the driver to operate the vehicle to allow the monitor to run.