How long do you turn on the ignition switch?
How long do you turn on the ignition switch?
Turn the ignition switch to the “On” position (as in step #1) for 11 minutes again. 4. Turn the ignition switch off for another 30 seconds. 5. Turn the ignition switch to the “On” position for 11 minutes a third time. 6. Turn the ignition switch off for 30 seconds one final time. 7.
How to relearn the GM ignition switch procedure?
GM ignition switch 10 minute relearn procedure 1 Security Indicator Lamp operation. The Body Control Module controls the security indicator lamp in the instrument cluster by sending messages to the instrument cluster over the class 2 serial data 2 Passlock Operation. 3 GM 10 minute relearn procedure. …
How do you turn on ignition with engine off?
Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON, the vehicle will not start. Observe the SECURITY light. After approximately 10 minutes, the security light will turn OFF.
How do you reset a Chevy S10 computer?
Turn the ignition on but don’t crank the engine. Press the “erase” button on the scan tool to clear the codes on the computer, then run the engine for approximately 10 minutes to allow the computer to fully reset itself.
How to replace the ignition switch on a GM car?
1. Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2.
Turn ON the ignition, with the engine OFF. Attempt to start the engine, then release the key to ON, the vehicle will not start. Observe the SECURITY light. After approximately 10 minutes, the security light will turn OFF.
Turn the ignition switch to the “On” position (as in step #1) for 11 minutes again. 4. Turn the ignition switch off for another 30 seconds. 5. Turn the ignition switch to the “On” position for 11 minutes a third time. 6. Turn the ignition switch off for 30 seconds one final time. 7.
Where is the PassLock sensor on a GM ignition switch?
If the security indicator lamp is illuminated continuously while the engine is running, there is a security system malfunction which will need to be diagnosed and fixed. This Passlock sensor is located inside the ignition switch and receives a reference voltage (5 volts) from the Body Control Module when turning the key on.
