How do you reset the security light on a 2003 Chevy Silverado?
How do you reset the security light on a 2003 Chevy Silverado?
The first thing You need to do is open the driver’s side door, and sit down inside. Next, place Your key in the ignition, and turn it to the on position. Be careful not to actually start the motor when You do this. Now, make sure the illuminated light on the instrument panel has gone out.
Can you bypass PASSLock?
To remotely start a car with this feature, you must bypass the PASSLOCK system. The second way, is to temporarily bypass the PASSLOCK, by introducing relays into the system, which retain all of the features of the system, while allowing your remotes start module to bypass it automatically during a remote start cycle.
What should I do if my PassLock security light goes off?
If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay.
How long does it take for PassLock sensor to turn off?
•Observe the security light located in the instrument cluster, after approximately 10 minutes the security light will turn OFF. Turn OFF the ignition, and wait 5 seconds. •The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
How often does a GM PassLock light flash?
You need a scan tool. If the signal is not correct, the PCM disables the injector and the starter and flashes the light once per second. If an illegitimate key is used or a system problem exists, the light flashes twice per second. This system allows starter operation, then kills the injectors 1-2 seconds after startup.
How do you turn off PassLock on a Chevy?
Key on, press volume till readout says SETTINGS then scroll to the Security to toggle off by pressing reset ( watch YOUTUBE). I personally see no sense of having no security system so try the RELEARN method. Other thing is that the Ignition Switch has a Sensor on it and the wire clip comes loose.
If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay.
•Observe the security light located in the instrument cluster, after approximately 10 minutes the security light will turn OFF. Turn OFF the ignition, and wait 5 seconds. •The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
When was the last time I had a PassLock problem?
2007–2014 50th of 80 563 2000–2006 57th of 80 419 2002–2009 71st of 80 2158 2009–2017 67th of 80 565 OK, Now What? Maybe you’ve experienced this problem. Maybe you’re concerned you will soon. Whatever the reason, here’s a handful of things you can do to make sure it gets the attention it deserves.
How to relearn the PassLock sensor data code?
Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds . Repeat steps 1 through 4, 2 more times for a total of 3 cycles/30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
