How do you replace the steering on a Chevy Silverado?

Slide the Pitman arm back in place and fasten the bolt. Reconnect the power steering lines, and re-install the lower fan shroud. Reattach the fan to the water pump. Rotate the fan clockwise, and then tighten the nut to a snug fit.

How do you replace the radiator on a Chevy Silverado?

Remove the two bolts that hold the radiator shroud in place and remove the shroud. Use a large Crescent wrench and rubber mallet to loosen the nut securing the fan to the the water pump. Rotate the fan counterclockwise to remove it. Figure 2. Loosen and remove the radiator fan.

How to replace the fuel pump in a 2004 Chevy Cavalier?

Chock the front wheels to prevent it from rolling off of the supports. Remove pressure from the fuel lines. The easiest way to do this is to remove the fuel pump relay in the engine compartment fuse box. Once the relay is out, start the vehicle and let it use the rest of the fuel in the system.

How to replace an air conditioner compressor in GM Chevy?

If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: xCjOs5a8mQyDggsT) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.

How do you replace the drive belt on a Chevy Silverado?

Attach a 15mm socket with ratchet and extension to the center bolt of the tensioner pulley. Rotate the bolt clockwise until enough tension on the drive belt is relieved. Then, remove the drive belt from all of the pulleys. Figure 6. Release the tensioner pulley.

How do you replace a rear wheel drive transmission?

Easy to follow step by step guide on how to replace or remove an automotive manual (standard) transmission for rear wheel drive vehicles, though appearances may vary, the process is the same on most vehicles. Tools and Supplies Needed Hoist or hydraulic jack with stands.

How do you remove a pitman steering box?

Remove the bolt on the coupler to the steering linkage. Remove the nut holding the Pitman arm to the steering box. Remove the Pitman arm using a Pitman arm puller. Remove the three steering box mounting bolts located in the driver’s side wheel well. Pull out the steering box. Figure 3. Remove the steering box.

How do you remove a power steering box?

Disconnect the rubber line to the power steering box using a pair of channel pliers. To do so, squeeze the clamps together and pull the line straight out. The line will leak fluid, so be sure to have a drain pan ready. Disconnect the second, hard line to the power steering box. Use a wrench to loosen the nut, and then pull the line straight out.

How do you replace the steering on a Chevy Silverado?