How do you replace a brake light on a Mustang?
How do you replace a brake light on a Mustang?
With all three nuts back in place, carefully replace the trunk trim back into the trunk. Replace the four center pin lock retainers by pushing them firmly into position. Now replace the two trim screws by turning them to the right.
Can a tail light be replaced on a 2005 Mustang?
Years ago, replacing a bulb was pretty simple. Owners of 2005-2009 Mustangs will find this task is a bit more involved than in the old days, as it requires removing some trunk trim and a few retaining screws. The entire tail light assembly must then be carefully removed to gain access to the bulb sockets in the rear.
What to do if your brake light is not working?
As you can see, one of the two brake light bulbs on this Mustang (in the center) is not working. Make sure your trunk is empty. Remove the plastic screws from the left and right side trunk trim. Remove the four center pin lock retainers from the trim panel. Using a flathead screwdriver or your finger, lift up the center of the pin.
What kind of light bulb do I need for my Ford Mustang?
Although Ford recommends using Sylvania 4057 or 4057LL, several people have reported success when using the Sylvania 3157LL bulb, which happens to be more readily accessible at local retail stores. As always, consult your owner’s manual or local Ford dealer for advice regarding the correct part.
When to replace the brake light on a Ford Mustang?
What follows is a step-by-step replacement of a brake light on a 2008 Ford Mustang. For information regarding other model years, please consult your owner’s manual or contact your local Ford Dealer . To do this, you’ll need the following: The total time required is about 15 minutes.
Years ago, replacing a bulb was pretty simple. Owners of 2005-2009 Mustangs will find this task is a bit more involved than in the old days, as it requires removing some trunk trim and a few retaining screws. The entire tail light assembly must then be carefully removed to gain access to the bulb sockets in the rear.
As you can see, one of the two brake light bulbs on this Mustang (in the center) is not working. Make sure your trunk is empty. Remove the plastic screws from the left and right side trunk trim. Remove the four center pin lock retainers from the trim panel. Using a flathead screwdriver or your finger, lift up the center of the pin.
Although Ford recommends using Sylvania 4057 or 4057LL, several people have reported success when using the Sylvania 3157LL bulb, which happens to be more readily accessible at local retail stores. As always, consult your owner’s manual or local Ford dealer for advice regarding the correct part.
