How do you remove coil packs from Dodge Ram?

You will hear them pop as they break free. To remove the coil packs, first disconnect the electrical connector plug. Slide the red tab on the connector to the unlock position and squeeze down on the locking tab while pulling the plug away from the coil pack. The only thing holding the coil packs in place now are the two 10mm bolts.

Where is the ignition on a Dodge Ram?

Squeeze the tab on the connector plug while pulling the plug away from the resonator box. You can now fully remove the resonator box from the engine. The 4.7 liter has two bolts located on each side of the resonator box. The bolt on the passenger’s side is below the intake pipe elbow.

Can a cop ignition coil go bad on a Dodge?

Now, although the COP coil ignition system on your Dodge 4.7L equipped pickup or SUV is a major step forward over a distributor based ignition system, you still have things go wrong. The most common of failures is a COP ignition coil going bad and causing a misfire (which in turn causes the check engine light (CEL) to illuminate).

How do you replace spark plug on Dodge Ram?

Check that the new spark plug is gapped correctly at 0.040″. Apply a small amount of anti-seize onto the spark plugs threads. Start threading the spark plugs into the hole by hand with an extension and torque to 15 ft. lbs. Slide the coil packs spark plug boot wires onto the top of the spark plugs.

Where to buy ignition coils for Dodge Ram 1500?

Once the field is full, a contract breaker opens to deliver the energy to the secondary coil so that the spark plugs can ignite the fuel and air mixture in the engine to start the car. Buy your ignition coils for Dodge Ram 1500 online from AutoZone and use Same Day Store Pickup to get your auto part at your convenience.

Where are the bolts on a Dodge Ram?

The 4.7 liter has two bolts located on each side of the resonator box. The bolt on the passenger’s side is below the intake pipe elbow. On the backside of the box is a crankcase vent hose that is easily removed by pulling it off of the box.

When to change coil pack on Dodge talk?

At 101,346 miles I am getting a cylinder misfire code. I am having the plugs changed and the service manager recommends changing the coil packs as well. What do you think?

How do you change the ignition on a Dodge Ram?

Before removing the box completely, make sure you have disconnected the air intake temperature sensor. To remove the resonator box on the 3.7 liter, depress the locking tab holding the electrical connector to the air temperature sensor while pulling it away from the resonator box.

Are there any problems with the Dodge 5.7 Hemi engine?

In no specific order, four of the most common 5.7 HEMI problems are: A few more general notes prior to discussing each of these common faults in-depth. Simply because we refer to these problems as common does not mean every 5.7 will experience them. Also, engines are subject to potential problems that we won’t cover.

Why does my Dodge Hemi engine keep ticking?

This seems to be the most common and serious cause of the Chrysler 345 HEMI engine ticking problem. It also appears most common on 2009+ models leading some to believe the multi-displacement system is to blame. It does make sense.

What causes exhaust leak on Dodge Hemi 345?

Broken manifold bolts on the HEMI 345 create an exhaust leak. If it’s bad enough then you may notice power loss. A lot seem to fail even under the warranty period, so initial failures should be fixed by the dealership at no cost. Otherwise, you may be on your own for the repair.

How many spark plugs in a 5.7 liter Hemi?

The 5.7 liter Hemi uses two spark plugs per cylinder with one plug attached to the coil pack and the other attached to a spark plug wire boot. The Hemi incorporates this design for better combustion efficiency and lower emissions.

How do you remove coil packs from Dodge Ram?