How do you remove a door lock on a Ford Focus?
How do you remove a door lock on a Ford Focus?
Turn the connecting rod a quarter turn to unhook it from the door lock cylinder lever, unclip the outer cable from the lock housing and give the inner cable a quarter turn to disconnect it from the door lock linkage.
Is there a problem with my Ford Focus?
I have a Focus ST 2007 pre facelift both doors would not lock/unlock correctly and the indicator lights did not flash to say the doors had locked or unlocked.
How to enable or disable ECU functions in Ford Focus?
ELMConfig – Enable/Disable Ford ECU Functions – James Simpson ELMConfig allows you to enable or disable Ford Focus, Kuga, C-Max, Mondeo, S-Max, Galaxy, ECU Functions, and also a ECU Fault Code Reader & Clear EML/CEL
Is there a remote central locking solution for a Ford Focus?
This solution worked for me i have a 2000 (x reg) 2.0 ford focus and the remote central locking didn’t work and the doors intermittently opened after manually opening the drivers door. did as instructed in the above posts now everything is back to normal, thanks for the useful information.
Turn the connecting rod a quarter turn to unhook it from the door lock cylinder lever, unclip the outer cable from the lock housing and give the inner cable a quarter turn to disconnect it from the door lock linkage.
How to remove side impact bolster from Ford Focus door?
Once the door’s trim panel is removed, remove the side impact bolster by rotating it counterclockwise to free it from its retaining clips. You should then pull those clips from the door panel.
How do you remove water shield from Ford Focus?
In order to peel back the water shield, cut through its butyl strip with a knife or scraper, making sure you don’t damage the weather shield, door panel or adhesive. To remove the bezel for the lock cylinder, loosen but don’t remove its retaining screw within the door handle assembly, then unclip it.
Once the door’s trim panel is removed, remove the side impact bolster by rotating it counterclockwise to free it from its retaining clips. You should then pull those clips from the door panel.
In order to peel back the water shield, cut through its butyl strip with a knife or scraper, making sure you don’t damage the weather shield, door panel or adhesive. To remove the bezel for the lock cylinder, loosen but don’t remove its retaining screw within the door handle assembly, then unclip it.
How do you turn on auto lock on Ford?
Step 1 Get into the car and close all the doors. Turn the key to the on position and press the power door lock button three times in a row. Push the power door unlock button once to turn on the auto lock feature. Turn the car off and listen for the horn to beep.
Is the auto lock feature on a Ford a blessing or a curse?
The auto lock feature on Ford vehicles can be both a blessing and a curse. Though they provide you the added safety of locking your doors as you travel down the road, you may not always realize the doors are locked when you exit the vehicle and could accidentally lock yourself out of the car.
How do you lock a car with a power door?
Turn the key to the on position and press the power door lock button three times in a row. Turn off the ignition switch and press the power door lock button three times.
Why are the doors on my Ford Focus not opening?
Yes it could be a safety issue but if the doors won’t open from the inside that would suggest it’s a failure on the lock. If you have a garage then this works better…
Is there a problem with unlocking the driver’s side door?
Yup, if the fob opens the other doors with the double click you could have problems with the driver’s side lock. Key locks don’t get used often, might even start working with some lube if the key is correct. Car was bought brand new so locks being switched is unlikely.
Why is the rear door lock on my Ford Focus not working?
The rear driver side door lock will not lock. The child safety lock doesn’t even make it work. All other doors work with the remote entry key fob and alarm activates but the rear passenger door remains unlocked. I can not even lock it manually.
Yup, if the fob opens the other doors with the double click you could have problems with the driver’s side lock. Key locks don’t get used often, might even start working with some lube if the key is correct. Car was bought brand new so locks being switched is unlikely.
Why is my key not working on my focus?
Might start by getting in through the trunk to open the doors from the inside. Don’t know right now if the car battery is even OK, or if it’s connections are good. total loss of electrical power is even a slight possibility. (door half unlocked when it died and then the key doesn’t work either?
Are there any problems with my Ford Focus?
Ford Focus owners have reported 6 problems related to power door locks not working (under the electrical system category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Ford Focus based on all problems reported for the Focus. Tl the contact owns a 2012 Ford Focus.
How do you fix a broken door latch on a Ford?
5) Slide the steel cable into the slot in the new aluminum cable ferrule, feeding the cable into the small diameter side first. Next push the black rubber sleeve of the cable into the ferrule, pushing it all the way in until it stops. You can check that it is in all the way by looking through the slot in the ferrule.
Is there a way to repair a Ford suicide door?
I got on the internet and I found that someone had made a Ford Door Cable Repair Kit that can be used to repair the door cables in a door, hatch, suicide door, third door, etc, without having to replace or remove the door latches. The kit is pretty affordable too! Much cheaper than the latches or cables from Ford.
What happens to the door cables on a Ford truck?
What happens is the door cables in Ford Trucks (F-150, F-250, F-350, Ranger) and Ford Vans (F-150, F-250, F-350) have plastic ends that keep the cables fastened in the door cable latches, and these ends corrode and break over time.
Why does my Ford Focus door chime go off every time?
Leave the key in, open the driver door then turn the truck off. This stopped mine from dinging. 20 people found this helpful. I have the same issue with my truck — I Park, shift into Park, Turn Engine Off, Remove Key from the ignition, Open Door to get out and the blasted Alarm/buzzer is going off — YES, I am trying to get out of my Truck!!
What causes a door lock relay to not work?
Power door locks do not function. Power door locks that do not function are another common symptom for a problem with the door lock relay. If the power door lock relay fails, it will cut off power to the entire power door lock system and may cause them to not function correctly.
Where are the fuse boxes on a 2012 Ford Focus?
This 2012 Ford Focus Fuse diagram post shows two fuse boxes; the Battery Junction Box/Power Distribution Box located under the hood and the Smart Junction Box/Passenger Compartment Fuse Panel.
Where are the fuses located in a Ford Focus?
Cigar lighter (power outlet) fuses in the Ford Focus are the fuses №39 (if equipped) and №46 (2000-2001) or №47 (since 2002) in the Instrument panel fuse box. The fuse panel is located below and to the left of the steering wheel by the brake pedal (behind the cover). The power distribution box is located in the engine compartment.
What to do if your door lock relay is not working?
Power door locks do not function. If your power door lock system is having any issues, or you suspect that your relay may be having a problem, have the vehicle inspected by a professional technician, such as one from YourMechanic, to determine if your car needs a door lock relay replacement.
Leave the key in, open the driver door then turn the truck off. This stopped mine from dinging. 20 people found this helpful. I have the same issue with my truck — I Park, shift into Park, Turn Engine Off, Remove Key from the ignition, Open Door to get out and the blasted Alarm/buzzer is going off — YES, I am trying to get out of my Truck!!
Why does my driver side door lock not work?
The windows and the locks are on two separate circuits. The only part that these two have in common is the master switch. Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact.