How do you remove a door control module?
How do you remove a door control module?
Pull the door module backwards and upwards. Remove the door module from its mounting on the door panel Press up the door module. To remove the upper panel, see Removing the upper panel. Page 1 of 4 Check Check that the control module connectors are intact. Installing the control module
How to replace driver door module and passenger door?
Position the door module in the hole on the door panel. Check that the lower mounting for the door module is correctly located in the support on the door panel Press the door module into place Connect the connectors Install the nut and screw Install the door panel.
When to replace a power door lock relay?
If the power door locks function intermittently or do not work at all, you may need to replace the door lock relay. Average rating from 130,525 customers who received a Vehicle Body Electrical and Lighting Inspection. Power door locks are a feature that has nearly become a standard feature on many newer vehicles.
What do you need to know about power door locks?
Power door locks are a feature that has nearly become a standard feature on many newer vehicles. They make the task of locking the vehicle’s doors as simple as pressing a button on the key fob or inside of the vehicle.
The module itself is removed by pinching two tabs at the top. So the module is out, and if you ask anyone at Mercedes Benz if there are any internals that can be fixed, they will tell you the door control module is “unserviceable.”
What to do with a C209 door control module?
Using small nails, you can gently pry open the plastic tabs enough to get to the good bits. As you can see, apart from a few big processors, there aren’t any fuses or anything that would really be considered easy to fix. This module is pretty much junk. On the bright side, you can save more than $700 by finding one on eBay.
What happens when the door control module goes bad?
It’s likely the door control module. This module performs multiple functions, and when it goes bad, it means all the controls on your door cease operating. But before you narrow it down to that, and shell out hefty cash for a new module, try the following checks instead. Does the passenger side window lower and raise as it should?
Is the Mercedes Benz door control module unserviceable?
So the module is out, and if you ask anyone at Mercedes Benz if there are any internals that can be fixed, they will tell you the door control module is “unserviceable.” I know remanufactured units use the core of old units, so with my curiosity in full swing, I decided to open the unit up.
How do you remove the passenger door module?
This method of removal applies to both the driver door module (DDM) and the passenger door module (PDM). The illustration shows the driver door module (DDM). Ignition off Remove the door panel Remove the nut and screw holding the door module Disconnect the connectors Pry up the rear edge of the door module.
When to replace the driver door module ( DDM )?
Replacing the driver door module (DDM) and passenger door module (PDM) Preparations Caution!€New software can only be ordered after the control module has been installed in the car. VADIS reads off the new control module identity which is required to order the correct software.
Why is the cowl not connecting to the driver side door?
Of course it is also possible that the wiring harness between the driver side door and cowl is corroded and that some of the pins are to corroded or even broken off and do not make contact. Also check that you have good and tight positive and negative battery cable connection to the battery posts.
Using small nails, you can gently pry open the plastic tabs enough to get to the good bits. As you can see, apart from a few big processors, there aren’t any fuses or anything that would really be considered easy to fix. This module is pretty much junk. On the bright side, you can save more than $700 by finding one on eBay.
