How do you relearn a Ford key?

How do you relearn a Ford key?

Ford Key Fob Programming Instructions

1. Close all doors on your vehicle.
2. Turn the ignition from OFF to RUN 8 times, within 10 seconds.
3. At this point, the door locks will lock and unlock.
4. Within 8 seconds, push any button on your Ford remote to begin programming.

How to relearn Pats ignition key code program?

Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”

How to relearn Ford Pats code erase procedure?

Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. 2 keys required. Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.

How do you reprogram a car ignition key?

For household cars with a vehicle identification number (VIN) that starts with 1 or 4, you can reprogram the key by taking the key into your car and entering the program mode. Step 1: Go inside your vehicle and insert the key into the ignition and turn it to the “ON” spot. Then leave it in that position for 10 minutes and 30 seconds.

How to relearn Ford Pats control function module?

Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.

Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”

Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. 2 keys required. Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.

How to program new Pats key for Ford manually?

3.Remove the existing key and, within TEN seconds, insert a second working key and turn it to ON (RUN) and the back OFF. Ignition must be in ON for at least ONE second, but no more than TEN seconds.

For household cars with a vehicle identification number (VIN) that starts with 1 or 4, you can reprogram the key by taking the key into your car and entering the program mode. Step 1: Go inside your vehicle and insert the key into the ignition and turn it to the “ON” spot. Then leave it in that position for 10 minutes and 30 seconds.