How do you lift a cab on a Bobcat 873?
How do you lift a cab on a Bobcat 873?
The best way to do this is raise the cab in the service position and then disconnect the hoses and electrical connectors. Then support the cab with a suitable lifting device. Once it is safely supported you then disconnect the pistons and then the rear pins at the hinge. Then lift off the cab.
How to remove a bobcat heater loader motor?
Next, at the rear of the cab remove the circle access cover located on the side of the cab to disconnect the heater valve, blower fan, and thermostat connector from the loaders wiring harness. ( Figure 1 ) [ Item 1, 2, & 3 ] Remove all four of the heater unit’s mounting nuts as show by using a 1/2″ socket.
How do you lower the cab on a Bobcat skid steer?
Lower the cab when done by lifting the cab slightly and pushing in on the lock mechanism on the gas cab support piston. This releases the the lock and allows the careful lowering of the cab.
Where are the nuts on a Bobcat skid steer?
These are located in the bottom of the cab on both sides of the door opening. Use the 19-mm socket to turn the nuts in a counter-clockwise direction to remove them. Remove the square washer located under each nut as well. Stand on the top step of the loader and place one hand firmly on the bottom of both entry-assist hand rails.
How to install a blower motor on a Bobcat skid steer?
To install the new Bobcat® heater blower motor, follow the the dissembly instructions starting from step 11 and work your way backwards through the steps. Need help removing or installing the blower motor on your Bobcat® skid steer?
Lower the cab when done by lifting the cab slightly and pushing in on the lock mechanism on the gas cab support piston. This releases the the lock and allows the careful lowering of the cab.
Next, at the rear of the cab remove the circle access cover located on the side of the cab to disconnect the heater valve, blower fan, and thermostat connector from the loaders wiring harness. ( Figure 1 ) [ Item 1, 2, & 3 ] Remove all four of the heater unit’s mounting nuts as show by using a 1/2″ socket.
These are located in the bottom of the cab on both sides of the door opening. Use the 19-mm socket to turn the nuts in a counter-clockwise direction to remove them. Remove the square washer located under each nut as well. Stand on the top step of the loader and place one hand firmly on the bottom of both entry-assist hand rails.
To install the new Bobcat® heater blower motor, follow the the dissembly instructions starting from step 11 and work your way backwards through the steps. Need help removing or installing the blower motor on your Bobcat® skid steer?
