How do you connect NanoStation?

How do you connect NanoStation?

Open your browser (e.g. Internet Explorer, Firefox, Opera, etc.) and type in address bar: http://192.168.1.20 (the default address of the Nano) then press the Enter key. Type in ubnt twice and click OK → (If this window did not appear, there may be a problem with the wiring, the network card or a firewall).

What is transparent bridge mode?

Firewalla Transparent Bridge Mode places a Firewalla device physically in the middle of an existing network without modifying the IP address of the network. A transparent Bridge Firewall is also called a layer 2 firewall, which can transparently filter traffic without detection.

Whats a WIFI bridge?

A wireless bridge connects two wired networks together over Wi-Fi. The wireless bridge acts as a client, logging in to the primary router and getting an Internet connection, which it passes on to the devices connected to its LAN Jacks.

How do I find my NanoStation IP?

How to find the IP address for your Ubiquiti access point?

1. Step 1: Download Ubiquiti locator. You can download the ubiquiti locator program here.
2. Step 2: Run the program. Once you have unzipped the file contents, click on the program file as outline in the picture below.
3. Step 3: Locate the IP address.

What is a nano station M2?

The Ubiquiti NanoStation M2 provides a secondary ethernet port with software enabled POE output for seamless IP Video integration. Intelligent PoE. Remote hardware reset circuitry of Ubiquiti NanoStation M2 allows for device to be reset remotely from power supply location.

How is The Nanostation 2 connected to the computer?

Make sure the Nanostation 2 (Nano for short) is connected to your computer’s network card with network cables, via the power injector (supplied with 12V either from the included wall-wart or another 12VDC source). There should then be at least one LED lit on the back of the Nanostation.

Is there a hard reset button on The Nanostation?

• Resetting device: Should you be unable to connect to the Nanostation after changing any settings (by mistake), it can be reset to it’s original default configuration (a hard reset) by pressing the reset button (little hole, inside cover) for 20-30 seconds, with the power on.

What should the IP address be on a Nanostation?

There should then be at least one LED lit on the back of the Nanostation. On the original Nanostation shipping box, find and write down the default IP address (we assume: 192.168.1.20), the user name and password (should both be “ubnt”). • Open Start/ Control panel/ Network Connections.

What does The Nanostation do as a router?

The Nanostation will act as a router which makes WIFI cruising life easier. (This refers to the WIFI side of the Nanostation)The Nanostation will be assigned an IP address, gateway and DNS server by the WIFI access point you connect to later. (This refers to the local wired side = you)