How do you change the cap on a distributor?
How do you change the cap on a distributor?
After the wires have been installed in the new cap, place the cap on the distributor and rotate it until the alignment tab allows the cap to drop into place. Reconnect the cap back to the distributor, and reconnect the short plug wire back to the ignition coil. Double-check all wire connections.
When to replace the distributor cap and rotor?
The cap and rotor are critically important for power distribution and need to be replaced periodically. Disconnect the negative battery cable. Locate the cap, with help from the vehicle owner’s manual or a repair manual, if needed. Loosen the distributor cap.
When to replace a distributor or ignition coil?
If you have a failed distributor or ignition coil, it is strongly recommended to replace the other related tune up components. Putting a brand new distributor or coil on a vehicle with old or worn spark plug wires and old/worn spark plugs is simply silly and will most likely cause you to replace the same parts over again.
Where does the rotor point in a distributor?
As cylinder #1 comes up to to the highest point, the rotor in the distributor needs to point to #1 terminal. You can turn the engine over with a breaker bar and a socket on the harmonic balancer bolt. Turn it clockwise until the timing mark is even with the pointer on the timing cover AND there is compression building in the cylinder.
After the wires have been installed in the new cap, place the cap on the distributor and rotate it until the alignment tab allows the cap to drop into place. Reconnect the cap back to the distributor, and reconnect the short plug wire back to the ignition coil. Double-check all wire connections.
The cap and rotor are critically important for power distribution and need to be replaced periodically. Disconnect the negative battery cable. Locate the cap, with help from the vehicle owner’s manual or a repair manual, if needed. Loosen the distributor cap.
If you have a failed distributor or ignition coil, it is strongly recommended to replace the other related tune up components. Putting a brand new distributor or coil on a vehicle with old or worn spark plug wires and old/worn spark plugs is simply silly and will most likely cause you to replace the same parts over again.
As cylinder #1 comes up to to the highest point, the rotor in the distributor needs to point to #1 terminal. You can turn the engine over with a breaker bar and a socket on the harmonic balancer bolt. Turn it clockwise until the timing mark is even with the pointer on the timing cover AND there is compression building in the cylinder.
