How do you change fuel pump pushrod length?

How do you change fuel pump pushrod length?

The engine is barely more than stock. Is this the correct fuel pump push rod. If not, what should it be. Thanks. stick a bolt in the hole in front of block and push the rod all the way up then install pump making sure the arm on pump is under rod then remove bolt from front of block and try.did you change rods or a different pump?

How do you install a fuel pump in a Camaro?

Thanks. stick a bolt in the hole in front of block and push the rod all the way up then install pump making sure the arm on pump is under rod then remove bolt from front of block and try.did you change rods or a different pump? I can recess the rod all the way up and I know my pump is going in all the way before I bolt it in.

How do I install a mechanical fuel pump?

After installing the pump remove this bolt and put the short one back in. No way you can loose the push rod inside the block so just slide it up the drilled hole. It butts against the cam so you know the general direction of the hole. put grease on the push rod to hold it in place while you bolt the pump on.

How do you install a pushrod on a block?

You take the cover plate off, install the pushrod and you will find it falls right back out. In the front of the block there is a bolt blocking a hole. Remove this bolt, install a longer one that will bump up against the push rod and hold it in place. After installing the pump remove this bolt and put the short one back in.

The engine is barely more than stock. Is this the correct fuel pump push rod. If not, what should it be. Thanks. stick a bolt in the hole in front of block and push the rod all the way up then install pump making sure the arm on pump is under rod then remove bolt from front of block and try.did you change rods or a different pump?

Thanks. stick a bolt in the hole in front of block and push the rod all the way up then install pump making sure the arm on pump is under rod then remove bolt from front of block and try.did you change rods or a different pump? I can recess the rod all the way up and I know my pump is going in all the way before I bolt it in.

After installing the pump remove this bolt and put the short one back in. No way you can loose the push rod inside the block so just slide it up the drilled hole. It butts against the cam so you know the general direction of the hole. put grease on the push rod to hold it in place while you bolt the pump on.

You take the cover plate off, install the pushrod and you will find it falls right back out. In the front of the block there is a bolt blocking a hole. Remove this bolt, install a longer one that will bump up against the push rod and hold it in place. After installing the pump remove this bolt and put the short one back in.