Easy lifehacks

How do you change drum brakes to disc brakes?

How do you change drum brakes to disc brakes?

Turn the adjuster wheel inside the access hole, which must be on the backing plate or the brake drum, and loosen the drum. Finally, remove it from its socket. If the vehicle is a front-wheel drive, detach the wheel bearings and the bearing cap in order to be able to disconnect the brake drum. What’s the Average Lifespan of Brake Pads?

How do you replace the brake on a Dodge Ram?

Rear brake assembly. 1. Disengage the secondary shoe return spring from the anchor pin. Figure 5. Secondary spring. 2. Disengage the primary shoe return spring from the anchor pin. Figure 6. Primary spring. 3. Push in on the hold-down retainer and turn it 90 degrees and remove the retainer, spring, and pin.

How do you remove the drum from a car?

Grab the brake drum by the edges and pull it off. It may help to wiggle it a bit as you pull. It may be necessary to back off the brake adjuster to remove the drum. This is done through the brake adjustment hole in the drum or on the backing plate using a brake adjuster tool to turn the adjuster to loosen the brakes enough to remove the drum.

Why are my brake shoes not moving on my Dodge Ram?

If for some reason after tapping it with a mallet it still refuses to move, it is possible that the brake shoes might have dug into the brake drum. To free them up, you might need to loosen the adjuster that is located on the back inside the brake drum and can be accessed by an opening in the backing plate.

Where to replace brake drums on Dodge Neon?

The Neon uses brake drums on the rear of the car only. You will find replacement parts through the Dodge dealer or at most auto-parts stores. Loosen the lug nuts on the rear wheels of your Neon with a lug wrench, but do not remove them from the studs.

How do you install a new drum on a car?

Insert a small flat screwdriver into the hole and lift the adjuster tang slightly, then slide a brake spoon into the hole and turn the adjuster down, pulling the brake shoes away from the drum. Grasp the drum with both hands and pull it straight off the brake shoes. Install the new drum, sliding it over the shoes and wheel studs.

How do you remove lug nuts from a neon?

Loosen the lug nuts on the rear wheels of your Neon with a lug wrench, but do not remove them from the studs. Raise the rear of the car until the tires are off the ground several inches, using a jack, then place a set of jack stands under the rear suspension to support the car. Remove the lug nuts from the wheel studs and set them aside.

Where is the inspection hole in a brake drum?

Locate the inspection hole in the brake drum backing plate from the back side. Insert a small flat screwdriver into the hole and lift the adjuster tang slightly, then slide a brake spoon into the hole and turn the adjuster down, pulling the brake shoes away from the drum. Grasp the drum with both hands and pull it straight off the brake shoes.

Author Image
Ruth Doyle