How do you adjust the injectors on a m11 Cummins?
How do you adjust the injectors on a m11 Cummins?
Hold the adjusting screw, and tighten the locknut. After setting the injector, set the valves on the same cylinder. With the “A” valve set mark aligned with the pointer on the gear cover and both valves closed on the cylinder to be adjusted, loosen the adjusting screw locknuts on the intake and exhaust valves.
How to set the OBC injector on the engine?
After setting the injector on a given cylinder, set the valves on the same cylinder. Notice that the OBC method requires new valve settings for the New Big Cam IV and the 88 Big Cam IV engines. Hold the adjusting screw and torque the locknut to 54 ft lbs on New Big Cam IV and 88 Big Cam IV’s and to 50 ft lbs on N14 models.
How to set up top end valves injectors?
Align the “A” or “1-6 VS” mark on the accessory drive pulley with the pointer on the gear cover. Note: It is important to adjust the injector first before adjusting the valves on a cylinder when using the OBC overhead set procedure.
How do you adjust the injector rocker torque?
Refer to the engine model and CPL for the correct injector rocker lever adjusting screw torque value. Use a dial type torque wrench to tighten the injector lever adjusting screws to the specified torque. If the screw causes chattering during setting, repair the screw and lever as required.
How is the injector and the valve interrelated?
The injector controls the fuel entering the cylinder. The valve controls the intake and exhaust valves of the engine. At the same time, the adjustment of the injector and the valve are interrelated in the adjustment sequence and method.
Where do I enter the injector correction code?
Injector barcode settings In the “New Barcode” field, enter the injector correction code for the corresponding cylinder. After the injector correction code has been entered, select “Apply” to proceed according to the procedure prompt until you see the message that the new correction code was successfully sent to the ECM.
The injector controls the fuel entering the cylinder. The valve controls the intake and exhaust valves of the engine. At the same time, the adjustment of the injector and the valve are interrelated in the adjustment sequence and method.
What do you need to test fuel injector resistance?
For this test, you’ll need a multimeter and the resistance value for the coil inside the injector. You can look up the injector resistance value in the service manual for your particular vehicle make and model. If necessary, buy an inexpensive, aftermarket repair manual at your local auto parts store or online.
Which is fuel injector assembly does Cummins use?
FUEL INJECTOR ASSEMBLY – KTA19 / QSK19 (PTK) FUEL INJECTOR ASSEMBLY – KTA19 / QSK19 (PTK) FUEL INJECTOR ASSEMBLY – KTA19 / QSK19 (PTK)
