How do you adjust the headlights on a Pontiac?
How do you adjust the headlights on a Pontiac?
Adjusting the headlights on any Pontiac vehicle is quite simple. Park the vehicle exactly 25 feet away from a blank wall with its headlights facing towards the wall. Use the tape measure to measure the exact distance.
How do you put a headlamp on a car?
Mark off the height, directly in front of the car, with electrical tape. Open the hood and turn on the low-beam headlights. You will notice that the headlights shine at the wall, and you can determine if they are aligned by where they fall in relation to the tape that you put down in step 3. Find the vertical headlamp aiming screws.
How do you adjust the beam of a headlight?
Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.
Where do you put the adjuster on the headlight?
These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights. The horizontal adjuster and the vertical adjuster should be marked. Always defer to the specs in the owner’s manual—some manufacturers recommend different distances for proper adjustment.
Adjusting the headlights on any Pontiac vehicle is quite simple. Park the vehicle exactly 25 feet away from a blank wall with its headlights facing towards the wall. Use the tape measure to measure the exact distance.
Where to place the vertical aiming screw on a headlamp?
Turn the vertical aiming screw with the 6 mm hex key. Do so until the beam of the headlamp is below the tape line from step 3. The top edge of the beam should be situated so that it is roughly two inches below the tape mark. Do the same series of steps for the opposite headlight, adjusting it to the proper positioning as well.
Mark off the height, directly in front of the car, with electrical tape. Open the hood and turn on the low-beam headlights. You will notice that the headlights shine at the wall, and you can determine if they are aligned by where they fall in relation to the tape that you put down in step 3. Find the vertical headlamp aiming screws.
How to adjust headlight distance from blank wall?
Step 1 Park the vehicle exactly 25 feet away from a blank wall with its headlights facing towards the wall. Use the tape measure to measure the exact distance. Use the tape to mark a spot on the wall that matches up with the exact center of the headlight you wish to adjust.
